is it possible?

[chile]

trying to keep it either 396 or 383

[94Blackbird]

Here it is. the columns in order, RPM, Flywheel hp, Flywheel Tq, Wheel Hp, Wheel tq. Had print it out and take a pic, screen shot wasn't cooperating with me.

[94Blackbird]

not to hijack, but what program are you using?

the program is labeled dyno sim.

[chile]

Thanks and wow that thing makes tons of torque really down low. I bet that would pull the big girl good

[94Blackbird]

Why is it to big?
It's 10ci bigger than the 396. And you can use off the self parts

Part of the stipulation is to keep it either 383 or 396.

[94Blackbird]

Thanks and wow that thing makes tons of torque really down low. I bet that would pull the big girl good

I pulled a little duration and widened the LSA in the program to get it to 503 wtorque. Didn't really lose anything up top either.

Just a reminder I got these numbers from a computer simulation, so take them with a grain of salt. I will say it's been pretty close, but it's more of an idea of what it could do if all the numbers matched. I have it running through large tube headers with no emissions or muffler for those numbers. If you need to run emmissions or mufflers that's going to bring the numbers down a little.

[chile]

I pulled a little duration and widened the LSA in the program to get it to 503 wtorque. Didn't really lose anything up top either.

Just a reminder I got these numbers from a computer simulation, so take them with a grain of salt. I will say it's been pretty close, but it's more of an idea of what it could do if all the numbers matched. I have it running through large tube headers with no emissions or muffler for those numbers. If you need to run emmissions or mufflers that's going to bring the numbers down a little.

I know these numbers arent set in stone but its a good start point.