Project Rainbow Unicorn 2013

**shownomercy** · 04-09-2012, 08:02 AM

I have the engine in my garage now, next up is buying a transmission for the car.

Does anyone know if someone does the re-pinning of a 96 LT1 harness to a 24x setup?

**RealQuick** · 04-09-2012, 08:16 AM

Matt, you receive the intercooler yet?

**shownomercy** · 04-09-2012, 08:18 AM

Yea it actually made it to work on Friday but I was MIA that afternoon

So grabbed it this morning, looks good sitting on my desk at work

**shownomercy** · 04-09-2012, 09:34 AM

Pardon the dirty car and missing elbow/throttle body

**AdamG** · 04-09-2012, 05:38 PM

how did you bend the pipe? Was it pre bent stuff or did you use a pipe bender.

**RealQuick** · 04-10-2012, 08:29 PM

Originally Posted by shownomercy

Pardon the dirty car and missing elbow/throttle body

Nice!

Adam - I bend U bends (180 degrees) and cut the angles I need.

**shownomercy** · 06-10-2012, 12:16 PM

Hot side clears a 7qt canton pan, big relief and thought you would wanna know Jon.

Pistons will be here some time before the end of the month.

**AChotrod** · 06-10-2012, 01:43 PM

I wish I could afford boost

! Kit looks great!

Oh and what did you guys run at the track???????

**shownomercy** · 06-10-2012, 02:14 PM

The old stock bottom end with LE2s went 12.1 @116 and then trans started to go, and it was just running consistent mid 12s.

This time round I am shooting for bottom 10s