- Navigation
Results 31 to 35 of 35
Thread: New Cam Times (Not Happy)
-
07-28-2009, 01:27 AM #31
95 Z28, 358, factory PCM, stock crank, LT4 intake, Trick Flow LT4 heads, solid roller, A3, 12bolt. 9.32@144
-
07-28-2009, 07:01 PM #32
That would be bad ass if you could. I am going to try and run this weekend sometime with the slightly updated tune and see what happens. I changed plugs and hope to see a 7 second pass.
Brandon
94 Z28 A4, Best 60'-1.797 1/8-8.02 1/4-12.98 at 104.37 SOLD!!!!!!!!
-
07-28-2009, 08:24 PM #33
Where you plan on running at?
95 Z28, 358, factory PCM, stock crank, LT4 intake, Trick Flow LT4 heads, solid roller, A3, 12bolt. 9.32@144
-
07-28-2009, 09:19 PM #34
probably here in Paragould at George Rays. It only cost $8 to watch or race and I am little tight on money right now
Brandon
94 Z28 A4, Best 60'-1.797 1/8-8.02 1/4-12.98 at 104.37 SOLD!!!!!!!!
-
08-28-2009, 10:50 PM #35
Hey guys have some new updates. I put in some new O2s last week and ran an 8.02 but then the next pass it ran an 8.32 cutting up. I took it to my mechanic who does the stuff I can't figure out and he found that number 6 plug was shot and hasn't fired since i put them in less then 200 miles ago. The plug had a a bad electroid and after changing the plug and fixing the short in the driver side O2 extension and getting the fuel injectors lined out it is on the right track. Either next weekend or the next I will be posting a new personal best.....
Brandon
94 Z28 A4, Best 60'-1.797 1/8-8.02 1/4-12.98 at 104.37 SOLD!!!!!!!!


Reply With Quote

Bookmarks