LTx converted and fully ported Brodix Track 1 heads

[Grr]

Just finished these up, they are fully ported very nicely and im not going to use them. They have a total of 4 dyno pulls on them and about 15min of break in. I dont have a flow sheet as i bought them second hand, but was told they flow 305/218. From what i can tell they have Ti retainers but i havent 100% checked.
The car they were on was a 12:1 383 lt1 with all the boltons and pretty big cam. It made 528whp @6900. They didnt pass the poke test at the pushrod pinch so i had to have them welded. They are done, i rounded a corner on one port a bit cleaning the welds (they were a fucker to weld up, it really sucked) but it will seal just fine i checked it with a gasket. they are getting machined to true them up tomorrow and cleaned.
$1000+shipping, or give me an offer!
228cc intakes
67cc chamber
2.08/1.60 8mm valves

[Grr]

Just want to add, make an offer i want these gone!

[Grr]

soooo, not even an offer. Just milled for flatness and cleaned, maybe ill just throw them in the scrap trailer since nobody wants to buy anything i have obviously

[tomsws6]

i wish just tight on the coin right now.

[Grr]

boxed up and ready to go, buyer fell through. Shipping will be 40-50$, so ill take 875 shipped to anyone interested

[OutCast]

Need more info and people are going to be cautious of heads that have had this type of work done to them. Can you post pics of what was done and shots of the intake and exhaust so we can see the port work. Are these for LT1 or LT4 intake?

thanks

[Firebat]

PM sent. Very interested.

[Mr.K]

pix pix pix

[Badhawk]

I have the track 1's on my car and should see some 10 sec slips in good weather. BTW my car put down 468 whp @6800 so these should make for a nice build laying down 528 whp.

Just curious was this on a auto or manual trans.
Good luck on the sale.

[c5formula]

can i get some pics of the heads and work done to them? also are these for an lt1 or lt4 style intake mani? have cash in hand an ready to purchase...