- Navigation
Results 1 to 5 of 5
Thread: jet chip/module?
-
07-20-2014, 01:55 PM #1Lurker
- Status
- Offline
- Join Date
- Nov 2013
- Name
- David
- Vehicle
- 97 355 Green TA
- Location
- Deltona, FL
- Posts
- 303
jet chip/module?
While reinstalling my pcm I noticed a black box that connects straight off the pcm, came with the car, it says JET on it and other than that I know nothing about it... I've done a little searching and found jet to be a performance chip/module company among other things. Anyone know what that black box is/does? Will it affect the tune I just got on the pcm specific to my new engine specs?
97 TA (Rebuilding):Stock bottom end 355, CAI, 52 TB, Ported intake and lt1 heads, 227/235 LE cam, Ultra-Pro-Mags 1.6RR's, Hooker LT's, single flowmaster, McLeod Clutch. Need a 9inch rear to handle the abuse
FLOGROWN
-
07-21-2014, 08:39 AM #2LTX Master
- Status
- Offline
- Join Date
- Aug 2013
- Vehicle
- 1994 z28 2005 gxp
- Location
- Wentzville, MO
- Posts
- 897
its a type of tuner. if i remember it a piggyback system where it doesnt alter the computer, but changes the parameters going into and out of the computer.
did the person who tuned your car do any datalogging and then tweak the tune? or was it a mail order where you just tell them what you got?
if its the later you should be fine removing it. if it was dyno tuned, or datalogged and tuned you might want to contact the tuner.
-
07-21-2014, 10:25 AM #3The FABRICATOR!
- Status
- Offline
- Join Date
- Jul 2011
- Name
- Chris
- Vehicle
- 1985 Monte Carlo SS
- Location
- southern illinois
- Posts
- 7,164

^ this. If it was a basic mail order based off of info you did on the car, you don't want to run it. Those piggyback systems are the equivalent of the resistor mods that were popular a while back that trick the pcm into thinking the car has a different iat or ect to lean out the air and fuel or adjust spark.
Chris
1985 Monte Carlo SS
Mods: 9:1 383 LT1, Ported Trick Flow heads, D1SC Procharger, 4L80E, 3.50 9"
Check out the M122 MCSS build thread here!
-
07-21-2014, 04:48 PM #4Lurker
- Status
- Offline
- Join Date
- Nov 2013
- Name
- David
- Vehicle
- 97 355 Green TA
- Location
- Deltona, FL
- Posts
- 303
I got a mail order tune from Solomon. So in this case I should just remove it from what u guys are saying?
Sent from my LG-VM696 using Tapatalk 297 TA (Rebuilding):Stock bottom end 355, CAI, 52 TB, Ported intake and lt1 heads, 227/235 LE cam, Ultra-Pro-Mags 1.6RR's, Hooker LT's, single flowmaster, McLeod Clutch. Need a 9inch rear to handle the abuse
FLOGROWN
-
07-21-2014, 09:11 PM #5The FABRICATOR!
- Status
- Offline
- Join Date
- Jul 2011
- Name
- Chris
- Vehicle
- 1985 Monte Carlo SS
- Location
- southern illinois
- Posts
- 7,164

Yes. Unless you provided him with some data logs of your current setup and he made adjustments from there
Chris
1985 Monte Carlo SS
Mods: 9:1 383 LT1, Ported Trick Flow heads, D1SC Procharger, 4L80E, 3.50 9"
Check out the M122 MCSS build thread here!
Reply With Quote

Bookmarks