FS : Wiesco Forged Aluminum Pistons / Sheet Metal Intake / Timing Cover / Camshafts

[noice]

Prices do not include shipping or Paypal Fees.

The list of items for sale:

Mike Jones LT1 Camshaft - $250



This is a dyno run of a 388 LT1 with this camshaft in it and stock heads. 449TQ @ 4700 437HP @ 5400


This is a link to the engine that this camshaft was originally in, the shortblock was sold and the buyer did not want the camshaft, this camshaft only spent one day on an engine dyno with 1/2 a dozen pulls.
http://ls1tech.com/forums/lt1-lt4-mo...ock-heads.html


95 LT1 Timing Cover - $30

This has been milled to clear a double roller timing chain on the inside of the cover. I have two of these covers and I use a Cloyes 9-3145 double roller timing chain on the engine with them.

fGzKU8Jh.jpg


Wiseco 5095H3 4.030" 1.125 pin - $250

These will work with a 3.75" stroke crankshaft and a 6" Rod
These pistons have a -13cc dish on them.
They do not come with piston rings, but I'll put the piston pins, locks, and oil rail supports in with them.

There is one of the pistons that has a mark on it that is shown in the high resolution picture, you can run this piston again.
http://i.imgur.com/ZpZoUjU.jpg

Here is the link to buy an individual piston though, they are $89 new.
http://www.jegs.com/i/Wiseco/926/5095H3/10002/-1

YMlsKOTh.jpg

lEPVX1Oh.jpg

5dSbu67h.jpg

nHIGqHKh.jpg


Single Plane Sheet Metal Intake - SOLD

I bought this single plane intake off a member of LS1tech long ago. I did not end up using it and had my own intake built for over $1500. I probably should have just run this intake instead of spending the money for a custom intake to be made. It has the holes for a direct port nitrous system.

QoGY0azh.jpg

GpTNaWlh.jpg

Thanks for reading.

[firebird_1995]

Hmm. I could slam a Whipple right on that intake.....

[noice]

Hmm. I could slam a Whipple right on that intake.....

For a time I was going to cover the front and put dual carbs on it and run it like a tunnel ram intake.

[MeanTA]

@noice

DIBS LOL
PM SENT ON INTAKE!!!!!

[ginoz28]

What troddlebody is that setup for?

[Mystery Bird]

Do you know who made the intake?

[noice]

What troddlebody is that setup for?

The 58mm bbk that the previous user had.

[noice]

Do you know who made the intake?

I dont know who made the intake I bought it in 2008 used and ended up paying over $1500 to have my own made.

It has been sitting since and that is why it is at $200. I can post more pictures when i get back from a business trip.

[MeanTA]

Im willing to pay now.

[firebird_1995]

What if I already paid?