kickout oil pan to k-member clearances

[95slowmaro]

im about to build my deep kickout oil pan for my lt1, whats the kickout pans or deep 7qt pans everyone is using? let me know part#s or pics. i want this to clear my stock k-member.

[MeanTA]

Im running a canton oil pan part#15-242T.

its 7.5 deep/12 wide/8.25 long

[95slowmaro]

did you have plenty side to side and forward clearance?

[MeanTA]

I had plenty of Clarence even with a stock K-member and hooker LT. And fit stock starter.

Im installing a tubular K-member when its warmer. And don't have any worries with it.

[Flyinz]

Good info.

How tall is that Canton pan, in the front? From where it bolts on the block, down to the bottom of the pan? Like 4 1/2" ?

[MeanTA]

Good info.

How tall is that Canton pan, in the front? From where it bolts on the block, down to the bottom of the pan? Like 4 1/2" ?

Im not for sure i will have to measure it.

[RamAir95TA]

With my Canton pan I used a Melling 10552 with Canton's 20-023 pickup. Worked great.

[95slowmaro]

i just built/building a kickout bottom 10 inches wide, 8 1.4 deep. adding onto a stock pan

[Flyinz]

Sounds like a good setup Joe. Did everybody have to drop the K-member to get the pan off?

[MeanTA]

Sounds like a good setup Joe. Did everybody have to drop the K-member to get the pan off?

Ya you will need to drop the k member. There isn't much room. I had my motor out of Tue car when i did mine though.