95 lt1 issues

[scarey1]

Hi, first,I just joined,not the best at navigation here,so.I am sure this subject has been covered many times. Here goes. I just bought a 95 Tarns am convertible, 101k miles,original owners,auto,green, trans perform button,all totally stock,grey leather,black top,loose rear window. I sat since 2007 with only occasional starts and movements around the block. I got it started after sitting 9 months,loaded it on a trailer and headed for home(200 miles) on the way,I blasted the snails and grime off the engine,and everywhere else. (ca clean car,no rust)

I went to start it up the next day and it would not,found a bad coil wire.(seems a mouse got it)replaced it and then it stared up and I took it for a quick spin ,ran good. I pulled it in the garage for the night. A couple of days later as i had some time,I pulled the 1/2 ass wire i made work for the coil and installed the new correct one.While there,i cleaned the throttle body with the correct cleaner. Went to start it and nothing .tried again and again. As soon as you let off the key...............it would try and run backwards blowing out exhaust thru the intake..............What the heck!.

Ok,I read up a little,possibly got the cap wet....well,maybe,I pulled the lower vent and stuck a hair dryer up there for 2 hours, still same thing. Now,I then dug into it...pulled the water pump(fun) cap is ready to come off....got to get the stupid reverse torx in town (30 minutes away)

Well,anyone think I am on the right track? Thanks,Scott

[Eric95ta]

Well, first off congrats on the purchase. It sounds like you are in the right track. Sounds like the problems are ignition related. I would start first with the basics, plug wires, coil, icm,plugs. If that dont do it, then it might be the good old opti... Good luck...

[Zlow28]

You can probably check to see if you damaged the iac valve while cleaning the throttle body. shbox has a page that shows how to check the iac using a multimeter. That might cause the car to not start, and maybe the exhaust air through the intake.

EDIT: and welcome to the site!

[popo8]

My money is on the Opti...

[96LT1355Z28]

-Have you checked fuel psi?
-Will it run with the gas pedal depressed?
-Is the coil putting out spark?
-Is there water in the base of the opti harness/ how do the pins look?

I know it's kinda late since you've already torn into it but awnsers to these questions can help!

[s-10fan262]

My money is on the Opti...

especially if u sprayed the engine...never get a lt1 engine bay wet.

[casey20000007]

My money is on the Opti...

Agreed might as well do the 24x conversion hehehe 😁 or just get a pro billet MSD neither are cheap but will be WAY better than another "stock" one


You can't pee on what you can't touch (chevy)

[Madman337]

especially if u sprayed the engine...never get a lt1 engine bay wet.

I have gotten mine wet and it was ALL BAD so hopefully its something like that and it will dry out, by the way Welcome to the site and you wont be sorry for joining since this is the BEST site on the planet for us LTX people.
I think its great to have another Cali member here now.