- Navigation
Results 1 to 2 of 2
Thread: LM-1 IAT setup
-
07-25-2012, 12:30 AM #1
InActive Member
- Status
- Offline
- Join Date
- Jul 2012
- Location
- SouthWest Minnesota
- Posts
- 244
LM-1 IAT setup
I am wanting to setup my IAT sensor to my LM1 does anyone know or have the temp(ohm) to volt conversion to make it work? I have the excel from their site but dont know what it is made form to figure it out.
Any help would be appreciated.97 Comp T/A #161 out of 164 LT1 383 stroker, TPIS/AFR heads, JE pistons, 9.3cr, extreme energy comp cams 224/230, Howards billet rods 5.85, Callies dragon slayer crank, 2 bolt mains converted to 4 bolt billet, Mildon oil pump, MSD opti, 6AL, boost retard, HVC 2 blaster coil, BBk 58mm, 50lb injectors, 3200 stall. Took 600b off to help fund twin turbo.
-
08-02-2012, 04:59 AM #2
InActive Member
- Status
- Offline
- Join Date
- Jul 2012
- Location
- SouthWest Minnesota
- Posts
- 244
I found what I was looking for and if anyone is interested in setting something like this up with their LM1/2 let me know I will pass on to what I have found.
97 Comp T/A #161 out of 164 LT1 383 stroker, TPIS/AFR heads, JE pistons, 9.3cr, extreme energy comp cams 224/230, Howards billet rods 5.85, Callies dragon slayer crank, 2 bolt mains converted to 4 bolt billet, Mildon oil pump, MSD opti, 6AL, boost retard, HVC 2 blaster coil, BBk 58mm, 50lb injectors, 3200 stall. Took 600b off to help fund twin turbo.
Reply With Quote
Bookmarks