Taking the motor out

[quickkris2006]

Ur 93 only has 60k miles??? Wow.. that's great! It must have sat a while to have all those leaks tho.. seals must have dried up

[jaysz2893]

Ur 93 only has 60k miles??? Wow.. that's great! It must have sat a while to have all those leaks tho.. seals must have dried up

yeah, it does sit alot. I bought it in 2000 and she only had 39K miles. I have a few old cars and I try to drive them as much as I can. Letting them sit is the worse thing you can do unless you drain it and put it in a museum.

[jaysz2893]

here is a recent pic. Got all the stuff off the motor, shoudl pull it off kmember this week. I am picking up the 355 this weekend..

[Neil350]

That car is so clean it is unfair, you dirty is nicer then my car ever. Best of luck

[jaysz2893]

well i got the 355 and it needs work. It is decent, but I want to go through it before installing it in my car. I pulled my motor apart and found al the rod bearings look fine. THe windage tray was cracked at the oil pump bolt. Weird cause the motor has never be apart. I may for now just put the heads and cam on my 350 if i find the noise. I am leaning toward a bad lifter. I will find out when I pull them out soon.

[chevymec]

Keep us updated!!

[jaysz2893]

well i decided to just rebuild my 350. I just installed all new rod and main bearings, water pump drive and the LPE cam. I am going to use the massaged heads off the 355 and gasket match my intake. I have to install new springs on the heads. I have the old MSD opti ready for the Delteq conversion. I got some cleanup done uner the hood and I am gonna clean up the Kmember soon. I just want to get rolling again. I need to send out for a chip for the cam. Hope to be running by middle of next month