- Navigation
Results 1 to 4 of 4
Thread: bellhousing bolts
-
12-22-2010, 05:43 PM #1
InActive Member
- Status
- Offline
- Join Date
- Nov 2010
- Location
- Peoria IL
- Posts
- 195
bellhousing bolts
Ok I'm extremely close to having this motor pulled. All i have is the top two bellhousing bolts and the motor mounts. The top two bellhousing bolts will NOT come out I have tried wrenches from the top and also tried to use an impact and extension from the bottom. I cant get the bolts to move at ALL. Any ideas???
-
12-22-2010, 06:10 PM #2
InActive Member
- Status
- Offline
- Join Date
- Nov 2010
- Location
- SoFla
- Posts
- 1,098
PB Blaster, and then heat. Use a MAPP gas torch to heat up the area where the bolt threads into. Fiore is yoor frieeennn as the ol' man says at work. Heat works %99 of the time
95 Impala SS Clone
-
12-24-2010, 01:42 PM #3
InActive Member
- Status
- Offline
- Join Date
- Nov 2010
- Location
- Peoria IL
- Posts
- 195
I ended up lowering the trans a little then using a long extension and impact from the bottom to get them out.
-
12-24-2010, 06:40 PM #4
Xtreme Member
- Status
- Offline
- Join Date
- Nov 2008
- Name
- Chris
- Vehicle
- 1994 Trans Am
- Location
- PA, USA
- Posts
- 2,471
Impacts are a beautiful thing. Glad to hear you got it out!
1994 Trans Am Under the knife - but it's alive!!! (5.3 LM7/CPT 60e/QP 9") BUILD THREAD
2009 G8 GXP M6, full exhaust, catch can, cai, stereo FOR SALE
1995 Trans Am M6 Junker | 1985 C10 new LQ4/80e Project | 1969 Camaro X11 Project
Reply With Quote
Bookmarks