Become a ltxtech.com member, Click here to register!

Results 1 to 6 of 6

Threaded View

  1. #1
    The FABRICATOR!


    Status
    Offline
    Join Date
    Jul 2011
    Name
    Chris
    Vehicle
    1985 Monte Carlo SS
    Location
    southern illinois
    Posts
    7,164

    Default 2017 LTX Shootout Modified NA Rules

    Modified N/A

    Qualifying, Ladder, and Tree Information

    Limited to quickest 16 qualifiers. Sportsman Ladder. .400 Pro Tree

    Vehicle/Body Rules

    Open to all year, make, and model vehicles. All vehicles must be stock bodied and stock appearing. Minimum race weight including driver 3000lbs.

    Engine & Drivetrain Rules

    Must have LT1 based engine (Factory LT1 Block). Cylinder heads must retain the factory 23 degree valve angle, Trick Flow 21 degree heads permitted (TFS-30400008-M54). Aftermarket heads and converted small block Chevrolet heads will be permitted if they follow the above guidelines.

    Aftermarket EFI PCM, LS1/24x PCM conversions, & Carburetors are allowed with a 100lbs weight penalty.

    Gasoline or E85 Only.

    Rear mounted batteries must be mounted and vented per NHRA specifications and have a functional disconnect switch.

    Any GM transmission allowed. Torque converters not permitted with manual transmissions and clutch activated automatic transmissions are prohibited. Line locks, trans-brakes and two-steps allowed. Throttle stops, delay boxes, and auto shifters prohibited.

    Any automotive rear axle permitted.

    No Power adder or power adder equipment allowed on/in vehicle during competition of this class.

    Wheels & Tires

    Any automotive wheel permitted. Tires must have a maximum height of 30” and a maximum tread width of 10.5” for bias-ply and radial tires.

    During competition passes, all vehicles will be required to weigh after each pass. Vehicles under minimum weight will be disqualified.
    Last edited by firebird_1995; 01-17-2017 at 08:48 PM.
    Chris
    1985 Monte Carlo SS
    Mods: 9:1 383 LT1, Ported Trick Flow heads, D1SC Procharger, 4L80E, 3.50 9"
    Check out the M122 MCSS build thread here!

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •