The never ending turbo camaro build

[dawdaw]

I ran straight nipples out of the trans housing to -6an pushlok, which fit fine, I wanted to avoid 90* fittings. Then a big ass B&M up front and derale fan unit under car.

Highly recommend these guys if you can fit em in your budget
http://www.summitracing.com/parts/jif-200t1/overview/

Smelly ATF is miserable.

didn't you y block yours and return them into a y back into the trans? had any good amount of street duty to see temps?

[shownomercy]

didn't you y block yours and return them into a y back into the trans? had any good amount of street duty to see temps?

Yes, but, I am not 100% on those temps now.

Exhaust dump melted connectors so they were getting hot externally.

[dawdaw]

are you dumping the exhaust right at the k member?

[shownomercy]

I was, aimed it by accident at the trans, so the trans temp sender I think got some external heat projected at it.

[Ryan Stout]

I have a hose barb 11x10x3/4" and a -6an 10x7x1.5" here. Opinions?

Sent from my SCH-I535 using Tapatalk

[shownomercy]

Go fittings, hose barb and hose clamp is rigged IMO.

MVB means high line pressures, don't cheap out.

[dawdaw]

With a manual valve body 4l80 can you run some form of aftermarket shifter? or using a stock one?

[shownomercy]

Yea, any gate/rachet shifter will work as long as you get it setup for a 4 speed.

[JCzNova]

True Street better watch out!

Sent from my SCH-I535 using Tapatalk

From what? You working on your ride on the trailer too close to the staging lanes?!

Hoping to see it run like a "Champ"
This year.... But not a "King!"

[Ryan Stout]

Gotcha. Think the an cooler is big enough?

Sent from my SCH-I535 using Tapatalk