Printable View
Yes. Looks like its going to take a minimum order of 10 pair to get started. I've thrown out the idea on as many sites/Facebook pages without trampling into sponsor territory. If you guys are members on other sites, please spread the word without getting yourselves in trouble. These will fit all models. Corvette, f-body, b-body, and of course swaps. Basically if you've got 1.25" of forward clearance on the water pump, it'll work.
I've been working with Lloyd on helping him design a new trigger for the optiQuote:
Originally Posted by Fastbird
You can put me down for a set Chris.
Quote:
Originally Posted by Fastbird
Fastbird; if it flys, I plan on a sponsership, no worries here, at this point it is all liability, no proffit.
you might PM me your sponsership schedual.
Granted its a block, but laser shops usually can't hold as decent a tolerance as a CNC. (depends on how fast they crank speed) Least thats the deal with my stuff. Have you looked into a wire EDM process? Or even an acid etch place may be able to bust that out easily.
I have not. I wouldn't even know where to begin to look for shop that offers that service. Do you have any suggestions?
I will look at the people will have on our list at work on Monday for you.Quote:
Originally Posted by firebird_1995
What kind of tolerance are you putting on these things and I assume 6061?
Honestly, id say within a 1/16" would work. 6061 thank you
Ok, a miscommunication has me with a few sets of these that I need to sell. I haven't had the time to install them in a non ewp f-body application so at the moment I am just going to sell the spacers with one set of gaskets (the top and bottom holes of the gasket have to be opened up to allow the shoulder of the longer bolts to pass through), no hardware, no extended drive coupling, shipped for $100. This will be for guys running ewp's only. The spacers are 1.25" thick. Take whatever space you have and add 1.25" to it before ordering to see if they will fit in your application. They will fit in my swapped g-body. They may fit b-bodys. At this point I'm just looking to sell what I ordered by accident and if there is any further interest in the future, they will run off in pairs at cost.