Any suggestions on pushrods and rockers?
Printable View
Any suggestions on pushrods and rockers?
My suggestion for push rods is to get a pushrod measuring tool to check and see what length push rod you need. As far as rockers go that depends on if you plan on doing a self-aligning or non self aligning setup
Sent from my SAMSUNG-SGH-I547
Er what? I don't know anything about rockers what would you recommend for someone who is learning
SA should be fine as long as ya dont plan to spin the motor real high.
Sent from my SAMSUNG-SGH-I547
I think I usually shift right before 6k when I'm at the track
I think I usually shift right before 6k when I'm at the track but regular driving around 3-4k
Is your Z stock right now?
I think I usually shift right before 6k when I'm at the track but regular driving around 3-4k
Gah so many post because it did go through no it's not stock I have long tube headers off road y pipe Texas speed performance rumbler catback(no cats though) k and n cold air intake
If you are planning on doing a more radical build down the road i would suggest getting the NSA rockers, Guide plates and hardened push rods now. No senses in buying SA rockers now, and then have to buy a different set down the road