can't get drivers LPP header in....

@LPP

2 of the 3 clamps had like a thing to go into a hangar... Not sure why I had them. Also, one clamp broke lol.

Y pipe comes close to my umi torque arm relocation xmember ad well. Y pipe doesn't bolt to the normal hangar off the trans either

http://tapatalk.imageshack.com/v2/14...f629c38cb2.jpg it fits you will have to shave the rubber mount a bit though

Interesting. I'll have to look again

Here they are installed.

http://i.imgur.com/gBgplQu.jpg

http://i.imgur.com/VmXB9Er.jpg

Just got my lpp's last week. Did you have to dent the drivers header to clear the steering shaft?

I didn't dent it yet. I might try putting in an LS shaft to see if that helps or grind down the stock shaft. I don't want to dent the header :(

dang I had to dent the crap out of my ebay header to get it to clear the steering shaft. that's why I bought the lpps hope I get lucky and have enough clearance. with my ebay headers I couldn't even get the shaft back on the car so I had no choice but to dent it like 1/2 inch. that was after I installed brand new polly mounts hoping it would help but they didn't.

I've heard you can loosen the colum and slide it over a bit but i have not tried it

These are larger tube headers , i bet if tgey were smaller tube headers they would clear right there