Printable View
So i have deleted my abs along with my cruise control. My question is, now that the abs is deleted i have 10 connectors just hanging not used. Before i put my new motor in, could i cut those wires that will not be used? Or should i keep them intact? Im unsure if cutting them off will affect anything else or if it will be fine? I have no plans to ever return it back to stock. Any help would be appreciated.
Sent from my SPH-L710T using Tapatalk
Anyone?
Sent from my SPH-L710T using Tapatalk
Can't help with cutting them mine are just hangin there
Yea i was hoping i could cut them but dont wanna cut the wrong thing. Haha. I guess ill just tie them up unless someone else has cut them.
Sent from my SPH-L710T using Tapatalk
There's a couple of large diameter hots in that bundle of wires. You could cut them off but make sure all the ends are covered and not able to touch anything.
Mine were cut out of the way.
Ok so as long as i cut them flush and like tape the ends ill be good? Or is there a better way? @Fastbird
Sent from my SPH-L710T using Tapatalk
Yeah. You're just making sure that any bare ends are safely covered and not going to hit anything metal, other wires, etc.
i cut them back and used crimp caps, then taped the hell out of them, and tucked them into harness. i vaguely remember cutting back two wires all the way to junctions iin the bigger harness
I cut mine and wrapped the ends with tape.