tuning issues/connecting ecm

Hello everyone,

Wondering if anyone could help me out? I had a tune from lt1pcmtune made for my 93 trans am and she is running good, but i think she needs some adjustments. So i purchased usb ALDL Cable for data-feedback and fine-tuning to send solomon. Purchased from aldlcables and so far I have tried datamaster, TunerPro RT, WinALDL to data-log while driving. I cant get any of them to connect to ecm, I have no idea what to do or try next. Any help would be great.

93 trans am (hampton, va)
91 octane
355 with edel cam
Lt4 heads
Long tube headers
Heated o2 conversion
Corsa exhaust
Msd opti
Ngk plugs
12 bolt rear w/4:10 yukon posi

Thanks

For TunerPro I had to go back to their site and download the different definition file for a '93.

http://www.tunerpro.net/downloadBinDefs.htm

The 8th one down IIRC.

Have you verified the data wire in the ALDL connector is working? Are you able to enter diagnostic mode and get the DTC 12 "handshake" flashed on the SES light by shorting the pins?

I can flash the codes by using a pin but when I try connecting the aldl cable and using my computer I keep getting no connection. I will try downloading again from site and see what happens. Thanks

Do you have the proper port selected on the program?

You may not have the USB-to-serial port drivers loaded for the cable. Check that with Control panel/device manager/ports. That will also tell you which port to use if the drivers are installed.

I have redownloaded the files and checked the ports and have them set to com4 and it says that the cable is working. But it just says connecting. Not sure if I am missing somthing but I cant figure this thing out.

Alright guys, i have attached screen shots of my settings and files. i downloaded DA2.ads, DA3.xdf files from tunerpro.

http://www.tunerpro.net/downloadBinDefs.htm

The 8th one down IIRC.

i then uninstalled tunerpro and usb aldl cable drives and reinstalled them and still getting the same issue, not connecting. once i installed the drives for the usb cable, i tested it using ALDL test v230 and it says its working. I am not sure what i am wrong here and really appreciate your guys help.
Attachment 28737Attachment 28738Attachment 28739 .

Attachment 28740Attachment 28741

The diagnostic pin to flash the codes is pin B (jumper to ground on pin A). But the data for the scan function is on pin M, at the far right end below pin A. Check that pin to make sure the pin isn't pushed out or the wire isn't broken. If you can measure the pin M voltage, reference to body ground (or pin A), it should be around 3-6 volts with the ignition on.

Also make sure you reboot the pc after installing any driver. What version are the drivers for the com port?