1995 formula parting out.

This is the demonbird from another thread. I got into an accident and went over top of a pretty big tree stump so it hit the front bumper a bit not bad could be fixed and really hit the front left tire hard. Bent the lower aarm and blew the shock. Also hit the underside under the drivers seat fairly hard and has the floorboard bent. The car could be fixed but I found a good roller, so it's just cheaper for me to part off what I don't need from this one for the new one. I do need the motor/trans. Driveshaft, rims and most of the panels and carpet from interior. So there's a lot left or if u want the whole car minus motor trans I will sell complete for cheap. Let me know whatcha need.

HAttachment 24103this is b4 the accident. This one is to show the floorboard is bent up pretty good. I don't think the Kframe was bent at all but kinda hard to tell for sure I think most of the damage is to the suspension on the front left side

Attachment 24104I only wants to let me upload one pic at a time

Attachment 24105 Here's the seats there bout perfect. One small burn hole in the back seat on the bottom part of it. The drivers seat is power and works as it sshould.
The rear end stuff is good. Bumper,hatch, I may sell the 10bolt it has 3.73 gears

throw up some prices with the parts bud.

MEMBER @ LTXtech.com

I'm just kinda on a make offer basis.
I was thinking bout 200 on the seats there basically perfect.
Grid tails and center piece 225$
Other than that and even on those I am negotiable
Or the whole thing minus engine,trans, and the interior plastics for $700

Quote:

---

Originally Posted by Ugod02010

I'm just kinda on a make offer basis.
I was thinking bout 200 on the seats there basically perfect.
Grid tails and center piece 225$
Other than that and even on those I am negotiable
Or the whole thing minus engine,trans, and the interior plastics for $700

---

I understand...and thank you...just a forum rule...

I know I wasn't sure really what to write since I'm just up for offers.
Anyways there's a lot of good stuff on the car guys. Hell it could be fixed just throw a lower aarm and the floor pans replaced. I just found a deal I can't pass on!

Also any prices are negotiable. Just need a few more $$$$ to pick up the new roller

you happen to have the front bumper mounting plates? the ones that mount the bumper to the studs. i need the drivers side plate and all the nuts... but ill take both plates so your not sitting on both...