Printable View
these are a std bore where in my SS when i bought it. in good shape, id reuse them again if i had another motor to use them in. ill get pics asap, they are out at my buddies shop. when i pulled the motor for the stroker the car ran ok as far as pistons... the bad motor was a couple failed bearings. like i said the slugs are in good shape. im pretty sure the pin is still with them too.
got any pix?
I'm heading there today to finish up the 14:1 lt1 so i will snap some pics.
any yet my friend?
GF stopped over and i got distracted LOL i asked my buddy to send me some pics as they are at his house. ill send him a message and tell him to get on it!
these are older pics before i had the rods removed. they are in pretty good shape, but they have been ran.
ok if you could get a little clear ones of the side skerts and the tops the flash kinda washed it out but im very into it
Are those valve marks?
no, they are a goofy valve relief. every piston has it, the car never dropped a valve or broke a timing set so there was never valve contact to the pistons, hell the same LT4 heads are on my 383... but yeah ill get some better pics for ya.