2010 SS Dyno results with Roto-Fab

[Speed Inc.]

We had done this 2010 IOM SS M6 back in Aug. and all the customer wanted was sound...LOL . We added SuperMaxx LT's w/ cats and kept the stock mid-pipes and axle back + a Dyno Tune.

STOCK AIR BOX AND FILTER

Results : 406 rwhp / 403 rwtq

The customer then wanted a little more sound after hearing our 2010 SS with the LM II, so we added that a couple weeks ago. I then got a call about adding a little more power so I recommend a CAI and Re-Tune. We chose to go with the Roto-Fab which is what we used on our 2010 SS and found it to work very well. We did a pre-dyno since he had added the axle back and some aftermarket 20" wheels and the results were just about the same.

Results : 406 rwhp / 402 rwtq ..had torque spike, so I put the cursor on to note realy TQ #

We then added the Roto-Fab and starting tweaking the tune and again we were very happy in the end with the Roto-Fab gaining power and torque everywhere.

Roto-Fab and Re-Tune

Results : 421 rwhp / 412 rwtq

http://i120.photobucket.com/albums/o184/svtspeed04/dyno-26.jpg

http://i120.photobucket.com/albums/o184/svtspeed04/dyno2-2.jpg

[Wooshie]

Those are some impressive gains.

[1FASTSS]

LS3's...:whistle:

[MoeHorsePower]

Those are some good numbers, I also did a 2010 SS with a CAI, don't know what brand, other than that it was all stock, started out at 371 RWHP and after tuning it went to 397 RWHP. Those dang motors are great..

[Speed Inc.]

yes..great motors to make power easily with

[MoeHorsePower]

yes..great motors to make power easily with


Yea, we also sprayed it, but I don't know if the customer wants to reveal that so I will let him post, I'll just say it made very good safe power...

[Speed Inc.]

I'm sure :)