Log in

View Full Version : BMR torque arm relocation bracket


firehawk238
03-07-2009, 10:35 AM
has anyone else here used one of these?? i attempted to bolt mine in and it didnt seem to fit like it should, so i didnt proceed with the install. if you have one on your car, can you post up a couple photos of it after the install was done??? also if you know of a better brand that may have better fitment than the BMR im all ears. thanks in advance

karl
Speed Inc.
03-08-2009, 08:47 AM
We have done a few and it's pretty straight forward. This just replaces the stock trans crossmember and the moves the front of the torque arm over.

6 speed P/N TCC011
4L60E P/N TCC012

what issues did you see?
firehawk238
03-08-2009, 10:38 AM
We have done a few and it's pretty straight forward. This just replaces the stock trans crossmember and the moves the front of the torque arm over.

6 speed P/N TCC011
4L60E P/N TCC012

what issues did you see?


did you have any issues with the torque arm trying to make contact with the fuel line mounting provision alongside the drive shaft tunnel?? i bolted mine up in and aside from not being able to pull the front of the torque arm over enough to get it bolted up, i found that it would be rubbing on the bolt that holds my fuel lines in place. any advice on this???
Speed Inc.
03-08-2009, 11:43 AM
did you have any issues with the torque arm trying to make contact with the fuel line mounting provision alongside the drive shaft tunnel?? i bolted mine up in and aside from not being able to pull the front of the torque arm over enough to get it bolted up, i found that it would be rubbing on the bolt that holds my fuel lines in place. any advice on this???

never had an issue with the torque arm itself being able to move enough

There are always little tweaks needed since nothing is true bolt-on.

can you email me a pic with it bolted up to show the issues?
firehawk238
03-08-2009, 12:58 PM
ill see what i can do, but its going to be a lil while before i get up under it again and attempt to put it in. waiting on my strange S60 to come in before i get too deep into it again.
grn95t/a
03-08-2009, 12:59 PM
we put one in my friends 94 z28. he went with a th400, so he had to relocate it. was abit tight but fit pretty good none the less. no pics sorry.