eclipseman
12-29-2020, 07:13 PM
I have a 2003 Cadillac escalade with 177000 miles, I lost fourth gear and what i now believe to be first gear( bad solenoid). I thought it was the sunshell, so took the transmission out sunshell was fine. With that many miles and that far tore down figured i should rebuild the whole thing, so i ordered all new clutches, gaskets torque converter and upgraded servo, sunshell, wide 2-4 band, input drum, etc.
Got it back installed and it now shifts through every gear but when it shifts into second it is like it goes straight into third. I bought a snap-on solus ultra so i could check to make sure the computer was telling the transmission to shift properly and it is. It shows up as second for alittle bit and shifts into third with no change to rpm or output rpm. I can turn all the solenoids on and off and hear them click from under the vehicle. If i manually change gears either with the shifter or the scan tool second and third there is no rpm change. Every other gear works perfect. Any ideas would be greatly appreciated.
Thank you,
Devin
Got it back installed and it now shifts through every gear but when it shifts into second it is like it goes straight into third. I bought a snap-on solus ultra so i could check to make sure the computer was telling the transmission to shift properly and it is. It shows up as second for alittle bit and shifts into third with no change to rpm or output rpm. I can turn all the solenoids on and off and hear them click from under the vehicle. If i manually change gears either with the shifter or the scan tool second and third there is no rpm change. Every other gear works perfect. Any ideas would be greatly appreciated.
Thank you,
Devin