Torque converter selection

[Cathead]

Guys, there's a lot of smart people on this forum and I appreciate your input. I have a 97 Z28 that I have decided to sell but before I do, it needs a new higher stall converter. The car is stock weight, T-tops and factory rear gear. The engine was rebuilt before I bought the car and the engine has a Comp Cams #467 so, because I intend to sell it, obviously, I would like to do this right but with minimal expense. I've been eyeing the 2800-3200 with lock up converter from Monster. Has anyone had any experience with this converter or similar setup, etc?

Sent from my SM-G955U using Tapatalk

[Camaro96]

I have not had any experience with monster. I will recommend contacting Cahall performance transmission and speak with Gail.

Sent from my VS996 using Tapatalk

[shownomercy]

More often than not, you get what you pay for.

Circle D, FTI, Yank, PTC etc are good brands

[Cathead]

I have not had any experience with monster. I will recommend contacting Cahall performance transmission and speak with Gail.

Sent from my VS996 using TapatalkYour right. Frank did an awesome job on my 94 Z28 and I will definitely use CPT again but only if I was going to keep this 97. I'm not in a position to put $2000+ more in this car's trans/converter to maybe get $3500 for it.

Sent from my SM-G955U using Tapatalk

[Camaro96]

Your right. Frank did an awesome job on my 94 Z28 and I will definitely use CPT again but only if I was going to keep this 97. I'm not in a position to put $2000+ more in this car's trans/converter to maybe get $3500 for it.

Sent from my SM-G955U using TapatalkI would contact Gail you can just purchase a converter from her

Sent from my VS996 using Tapatalk