Sergiodpk
03-06-2019, 10:49 PM
Well...........I have a new project. A buddy of mine brought his car to me a few weeks ago, after hearing a loud bang from the engine. After pulling the 383 out, tearing it down, I found #3 rod had broken. Amazingly, the block hadn’t sustained any major damage. Besides the #3 intake valve slightly bent, no damage to the AFR 195s. Currently the block, heads and internals are at my machinist being prepped for a rebuild.
Current setup
95Z28
2 bolt block
Scat 9000 3.75
Scat 6” rods
Icon forged .040 over
Comp Cams XFI280
AFR 195 1039 (tel:195 1039) heads comp ported
Edelbrock LT4 red intake manifold
58mm TB
24x Torqhead swap
Pacesetter LTs 3” magnaflow exhaust
T56 3.73 out back
Last Dyno put down 414rwhp 397rwtq
After building the bottom end a little stronger, I’ll be making slight mods to up the power. I’ll keep you guys updated.
Current setup
95Z28
2 bolt block
Scat 9000 3.75
Scat 6” rods
Icon forged .040 over
Comp Cams XFI280
AFR 195 1039 (tel:195 1039) heads comp ported
Edelbrock LT4 red intake manifold
58mm TB
24x Torqhead swap
Pacesetter LTs 3” magnaflow exhaust
T56 3.73 out back
Last Dyno put down 414rwhp 397rwtq
After building the bottom end a little stronger, I’ll be making slight mods to up the power. I’ll keep you guys updated.