EWP LED?

[DarkSSide]

Is there a kit or some type of diagram for a warning light when the ewp goes out?

[JCzNova]

Is there a kit or some type of diagram for a warning light when the ewp goes out?

I remember finding one on shbox.com a few years ago. Not sure if that site is still up and/or if it’s still there.

[BALLSS]

Wiring in a light/buzzer to a inline flow switch in the heater hose would show if WP was "pumping" as the other types just show if it is getting +12v which does not indicate if a ground dropped or the EWP itself was not turning

...but for me in the 19 years I have had my EWP....I just keep and eye on the temp, and other, gauges.

Another option would be to install a "A" pillar gauge, water temp, with a programmable alert temp that activates a light in the gauge

Or mount the gauge in the lower bezel of your instrument cluster

[Injuneer]

Shoebox is alive and well. He does have a circuit for adding an LED to a manual fan switch, but I don’t recall one for an electric WP.

http://shbox.com/1/4th_gen_tech1.html

[SSlowBoat]

Shoebox is alive and well. He does have a circuit for adding an LED to a manual fan switch, but I don’t recall one for an electric WP.

http://shbox.com/1/4th_gen_tech1.htmlOP Google it, there's a wiring diagram on the impala forums

I talked to shoebox, he said he will have the site around for as long as possible, and when he decides to pack it in I may take it over

Sent from my SM-N950U using Tapatalk

[shownomercy]

I have always wondered why folks will see a light going off, but not see the gauge cluster creeping.

[JCzNova]

I personally wired one because I was driving my project before I had a full set of gauges.