PDA

View Full Version : I have joined an elite group of people



agenthol302
12-07-2016, 09:37 AM
who have successfully blown up an Allison Transmission. pump failed and fried clutches FML

shownomercy
12-29-2016, 02:40 PM
People blow them up all the time?

How large of a tune did you have on it?

agenthol302
12-29-2016, 02:55 PM
No tune, Stock 8.1L

shownomercy
12-29-2016, 03:14 PM
Ah. Cause duramax's blow em up rather often :lol:

https://www.facebook.com/Limitless-Diesel-Performance-LLC-1408120042780172/

http://inglewoodtransmission.com/jm1/

agenthol302
12-30-2016, 11:48 AM
Founds a used one from my vendor for cheap with a 3 year warranty so went that route

harner
12-30-2016, 01:19 PM
Wow, impressive. Were you towing at the time?

agenthol302
12-31-2016, 03:06 PM
its got 240k on it, I put 10k on myself mostly puling the car and open trailer. he was a pipeline welder and owned it new. supposed to get it back next week!

zooguy
12-31-2016, 09:04 PM
do you have and mods done to the 8.1L / 8100 vortec / 496cid BIG BLOCK?
my father has a 2001 2500 crew cab 2wd with the big block and Allison Transmission it has about 265k and is all stock with a K&N filter.
i kinda want to get his motor and mod it some and use it as a motor to swap into a something ... maybe even a 4th gen Firebird

harner
01-02-2017, 01:14 AM
The 8.1 is a good motor, especially with the LS ignition. But, it's still an old school BBC. It would be cheaper to do a 4.8/5.3/6.0 build, but the big cubes would sure give bragging rights. They eat gas but have plenty of power and grunt.

You don't see it often, but many people have swapped them into all kinds of cars/rat rods/etc.

My Dad has a 4.8 in his '00 Silverado that I called dibs on years ago if something ever happened to the truck. Haha - 200k and runs better than the 5.3 in my truck. I think it's a factory freak that needs some turbo love...and it would all look great in my third gen.

Catmaigne
01-02-2017, 11:22 AM
The gen 7 8.1 is a cool motor but also an oddball. There isn't any compatibility with the top end so modding is difficult. The gen 6 454 from the late 90s is a better choice for modding despite less cubes. It's full roller, 4 bolt main, and will take mark iv heads.

Imagine... Turbo ls power without the turbo.

Sent from my VS986 using Tapatalk

agenthol302
01-03-2017, 12:46 PM
no mods done mines stock. not much out there for mods on this