Trans cooler mounting question

[bustedassz28]

I have a tube and fin style cooler, just wondering if i can mount it vertically with the inlet and outlet both facing down,(i'm bypassing the radiator cooler btw), only asking because of space constraints and routing configurations, thx guys. Cahall

[SSlowBoat]

I have a tube and fin style cooler, just wondering if i can mount it vertically with the inlet and outlet both facing down,(i'm bypassing the radiator cooler btw), only asking because of space constraints and routing configurations, thx guys. Cahall
Yes, but you shouldn't bypass the trans cooler in the rad, Trans will run hotter, and you should mount it horizontal with the inlet at bottom and outlet at top to prevent foaming. Also, tube and fin coolers are not as efficient as stacked plate coolers as the tube bends actually add friction and don't allow for as much thermal efficiency.

In closing, don't bypass rad cooler, run it in series.

Sent from my SAMSUNG-SM-G935A using Tapatalk

[bustedassz28]

Thx for the response, I did read the sticky that states as you did and it know my setup isn't optimal, this is temporary for tuning n shakedown runs, just didn't wanna cook the Trans, thx again

[shownomercy]

There is always more than one way to run things. And one sticky does not make the only way to do.

[SSlowBoat]

Thx for the response, I did read the sticky that states as you did and it know my setup isn't optimal, this is temporary for tuning n shakedown runs, just didn't wanna cook the Trans, thx again
Don't do back to back runs or you may, the fluid takes a while to cool off as a stand alone. I had mine like that for a bit of time, Trans temp would go to 200 and just sit there. When I hooked it back up in series it went down to 165 all the time

Sent from my SAMSUNG-SM-G935A using Tapatalk

[bustedassz28]

There is always more than one way to run things. And one sticky does not make the only way to do.
Agreed, that's why I posted looking for personal experience, thx guys appreciate it

[Injuneer]

Perma-Cool fan assisted fin and tube (I know, no one here likes them). No cooler in the radiator (a Griffin, originally built for a manual trans setup). As recommended by the guy that built the TH400.

Just an idea......

[shownomercy]

Agreed, that's why I posted looking for personal experience, thx guys appreciate it

I run a stacked plate cooler with no radiator heating.

[95formula383lt1]

I have mine mounted in front of the radiator temp never goes above engine temp.

Sent from my SM-G925V using Tapatalk

[SexyTransAm]

i have mine goin to the stock cooler in the rad then to a plate cooler mounted in front of the rad. and have a 160 thermostat. my trans temps never go over 180 on a hot day hot lapping the car. I.E. the shootout the last few years in true street

[myltwon]

I run mine thru the radiator then to a b&m super cooler

[bustedassz28]

Perma-Cool fan assisted fin and tube (I know, no one here likes them). No cooler in the radiator (a Griffin, originally built for a manual trans setup). As recommended by the guy that built the TH400.

Just an idea......
Is that fan a pusher or puller ??? Hmmmm....

[SSlowBoat]

Is that fan a pusher or puller ??? Hmmmm....
With a fan things are different. I had good luck "dope mounting" it like Injuneer shows above, used a cbr900rr radiator fan lol

Sent from my SAMSUNG-SM-G935A using Tapatalk