Switch for fan

[MI6TA]

I've looked on shbox and other forums and must admit, I'm not very savvy with car electrical. I can wire a house for you [day job], but can't make. Simple switches on a car lol. I'm carb converting so I don't know just yet if I'll still be using all 3 relays for the fans. I've seen that they use a lot of juice on start up so it's dangerous to just hook up one relay and a fuse to both fans... Can someone make it simple for me? I have the switch panel ready. Starter and water pump is working perfectly, need fans!
http://images.tapatalk-cdn.com/15/06/17/9f5962078a093fa05bdf120aa3a0f0f8.jpg
can't figure out why the pic isn't normal orientation...

Sent from my LGLS740 using Tapatalk

[Chris]

Ground Circuit 335 for low speed fans
Ground Circuit 473 for high speed fans

Simple Simple just a ground control circuit so you dont need any thick gauge wire going to the dash.

You could always leave the PCM piggy backed to operate them?

http://shbox.com/1/fan_schematic_1995.jpg