stock axle question

[shippy8907]

Are stock axles 28 spline? I'm planning on getting a mini spool and see there are options for 26 spline and 28 spline and even 30 spline. It is a 94 z28 by the way.

[shippy8907]

Also is the process that much more involved if I am taking a posi unit out instead of just the spider gears?

[sweet-94z28]

If you are going to do a mini-spool, your best bet would be to pick up a rear end from a v6 because I think you must have an open carrier to install a mini spool. I could be wrong though.

[shippy8907]

It looks like its the same setup minus having the plates with the springs and the clutches. It should be the same width across as an open carrier I would think. I'll have to do a little bit of research and see.