fuel line tuck holes

[miller09]

could someone show me a picture of where you drill the holes in the drivers side inner fender to run the stainless braided lines through? I did the wire tuck now I am working on the fuel line tuck just don't want to drill in the wrong spot. thanks

[Fastbird]

See attached:

28142

[96LT1355Z28]

Here's where I did mine, sorry it's not the best angle and I don't have any pics with the plastic wheel well removed.
2814328144

[Sahara54]

Same as fastbird...sorry no pics but I used some fuel line cut down the center and rtv'd in place to protect the lines as a ghetto grommet.

[Fastbird]

I cut the hole in mine to mimic the stick location so I could reuse the factory grommet.

Posted from my LG G2

[Sahara54]

I cut the hole in mine to mimic the stick location so I could reuse the factory grommet.

Posted from my LG G2

I'm not that fancy...outta sight, outta mind. Plus I stuck the factory grommet back in the orig sport to fill the hole.

[Spartan7]

If I had to do it again, I would move the top hole down next to the lower one. The fuel line interfered a bit with the wiring harness, but it still worked. The small hole is for the EVAP line. The grommets I picked up from Home Depot.

28153

28154

[GreenZ96]

I cut the hole in mine to mimic the stock location so I could reuse the factory grommet.

Posted from my LG G2

I did the same

Sent from my HTC6435LVW using Tapatalk

[miller09]

thanks guys I got it done.:D