MWC Fab9 brake line routing ??

[Z28-50]

Anyone have pics of brake line routing on a MWC Fab9 with LT1 brakes?

[dawdaw]

96LT1355Z28

maybe josh can help you... don't know what your having issues with.. run some 3/16 hard line along the housing, buy a couple braided lines to connect each caliper and depending on if your a 4 or 3 channel car you will need one or 2 braided lines to connect to your factory hard lines that are on the drivers side by the center section...

[Z28-50]

Well I was wanting to reuse the existing lines is possible.
No real issues yet. Just getting ready to install and looking for pics that reused the original lines.

[dawdaw]

Don't think your going to re use stock lines, maybe if you bent them.around the center of the housing but I think you'll be short.

[96LT1355Z28]

I reused my stock steel lines back in 2007 cause I was completely out of $! I've since had the rear end shortened so the rubber hoses at the ends are probably flexed more than they're supposed to be but I've learned to not mess with it if it works with this car! It's pretty crude lookin but hey it's not a show car right! Here's some pics please ignore the dirt/dust. I replaced several sections of sheet rock in my garage and the car was inside for half and outside in the rain for the other half.
28116281172811828119

[Z28-50]

Thank you Josh and Kyle.

Charlie