Question about Strange S60 install

[1QUICKZ28]

Seeking some advice. I just purchased a Strange S60 with drive shaft. The sway bar mounts lower on their axle compared to the stock 10 bolt. Axle housing is larger and mounts hang lower. I need longer sway bar end links. Can anyone tell me what they used in this swap? Or can I just remove it? I already removed the front sway bar so I'm not sure if its a good idea to remove the rear one too. I called Strange and they have no idea what to use.

[JPack]

Buy a umi rear drag bar.

[93M6Formula]

Hmmm....Mine came with new brackets and bushings so I could use the stock sway bar? I will be buying a dragbar soon though.

[96LT1355Z28]

So your saying the mounts are lower to the ground? Your stock stuff should work, the mounts are probably lower to allow the needed clearance for the bigger center section. As for the endlinks, if you feel the stock ones are too short you can buy universal ones at your local parts store. Energy Suspension and Prothane both sell them in a varaity of legnths.

[97firehawk]

Strange sent me endlinks with my s60 that are longer

[1QUICKZ28]

Strange sent me endlinks with my s60 that are longer

Any chance you can tell me how long the bolt is? That will give me an idea. I bought it off a guy who had it sitting in his garage for about 6 months. It's new and was still bolted to the crate. Picked it up with sub frame connectors and a 8pt roll cage for $2200. All new :D No end links were with it.

[Featherburner]

Strange sent me endlinks with my s60 that are longerThis.

[devildog1]

I used UMI torque arm relocate and it bolted right up. Good to have and has drive shaft loop.

[1QUICKZ28]

Thanks for the advice. Went to Energy Suspension's web site. Found out how to measure and ordered them from Summit.

[97firehawk]

Any chance you can tell me how long the bolt is? That will give me an idea. I bought it off a guy who had it sitting in his garage for about 6 months. It's new and was still bolted to the crate. Picked it up with sub frame connectors and a 8pt roll cage for $2200. All new :D No end links were with it.

Good deal I'll try and see how long they are even tho you know how to measure them . Looks like 8 inches.