Tune needed for rear gear swap

[nateleduc]

I have a TA with a T56, I crushed my 10 bolt and have another 10 bolt with 2.42s in it that I want to swap in. Do I need to have my PCM retuned?
I'm downgraded to OBD1 amd have everything needed to tun and flash my PCM.

Any ideas/help?

[Ninja Mihail]

Your speedo will be off but other than that everything else will be ok and by you saying 242 i hope you meant 342 stock gears are 273 323 and 342

[nateleduc]

Not 100% but it came from an Auto, and I know its pretty low. I'll have to pop off the cover and check. How hard is it to retune for lower gears?

[Ninja Mihail]

its not but you have to have tuner cats soft ware if it came out of a auto it will either be 273 or 323

[nateleduc]

Probably 273. I do have tunercats installed

[Ninja Mihail]

THEN ALL YOU HAVE TO DO IS INPUT YOUR REAR GEAR AND TIRE SIZE AND YOU ARE SET

[nateleduc]

THANKS NINJA MIHAIL. WHY ARE WE SHOUTING AND WHERE IS THAT LOCATED?

[Badbird_96]

Dont forget the 3.08 ratio

[nateleduc]

Got it. Attached is a OBD1 94-95 LT1-T56 6 speed with a 2.73.1 radio on stock tires (245-50 R16)

No EGR,CAGS, or A.I.R

I hope this is allowed. I couldn't find the rules anywhere

If you have a different gear ratio you want tuned just PM me ;)

Enjoy :)