innovative lm-1 wideband analog output question

[firebird_1995]

ive got an lm-1 and it has built in narrow band simulation via an analog output. innovatives instructions say to connect output 1 to the purple (o2 + signal) and to leave the rest unhooked. i tried this and scanning in freescan the voltage just hangs out around .45x volts while idleing with a warm engine. i tried connecting the ground and it pegs out at 1.0x volts. anyone successfully used an lm-1 to send narrowband signal to the pcm?

[toolman1981]

I did through the AC psi sensor input. If you dont mind spliceing a few wires it works great. There is a good writeup on camaroz28.com that list all the values to put in. Im useing datamaster.