PDA

View Full Version : 97 Camaro Z28



hbgben
05-11-2010, 10:09 PM
1997 Z28 6-speed, 100k miles. Recently converted from an A4, LS1 alum. DS, 4:10 gears, Pacesetter LT's, Pacesetter ORY, Magnaflow Cat-back, K&N CAI, CRT intake elbow, Spohn trans style torque arm, UMI torque arm relocation bracket, and A/C delete pulley. Also have converted the low beams to 9006 and have HID's in the low beams and have them for the fog lights.

Car has been dynoed on a Dynojet, 295.7 hp, 348 tq

All emission parts are removed as well as the A/C. Stock exhaust and other stock parts go with sale. Other parts are A4 stock torque arm, stock steel driveshaft and stock 3:23 gears. LS1 front brake upgrade available for additional $150

I have owned this car since Sept of 07, since then I have installed, cap, rotor, plugs, wires, new rad. cap, and both outer tie rods. Alignment is good. Car is tuned for emissions.

Also have personalized plates on the car, those are transferable if wanted. $100

$5,200 obo
http://i51.photobucket.com/albums/f376/carboncivicsi/IMG_0885.jpg
http://i51.photobucket.com/albums/f376/carboncivicsi/IMG_0887.jpg
http://i51.photobucket.com/albums/f376/carboncivicsi/IMG_0888.jpg
http://i51.photobucket.com/albums/f376/carboncivicsi/IMG_0890.jpg

BIGT94z
05-12-2010, 03:18 PM
mani wish u were closer to missouri

hbgben
05-12-2010, 07:55 PM
CAR IS SOLD

Tarheel'Z'
05-12-2010, 08:19 PM
that was fast,,congrats on the sale and congrats to the new owner

hbgben
05-12-2010, 09:00 PM
thanks

96speedZ28
05-17-2010, 08:01 PM
Thats a lot of torque for a bolt-on LT1