adj torque arm making bad clunk

[jss97ss]

hey ive got a umi tunnel mount adj torque arm put it in its been making a loud clunk usually at low speed in reverse or when im on the throttle hard then off have a virbration but its not from the torque arm everythings tight i just dont know if it just does that has anyone else had this happen or what any info helps thanks

[TA the destroyer]

do you have the stock rear? i heard of this problem with people running differnt rear ends, cause off them being off centerd. i also heard of this with the stock rear, i remember the guy changed his shocks and struts and it went away. and some poeple putting a piece of rubber between the part where it knocks and the floor bord.

[jss97ss]

yes stock rear with 4;10s has koni adj shocks stock springs its pretty annoying it feels like the front of it is disconected n thumping around

[TA the destroyer]

have you contacted umi about it?

[AChotrod]

I gave up on mine. It sucked big time no matter what PA it was set at. I now have a full length TA and TA relocation trans mount and couldnt be happier. Just sell it now;)

[jss97ss]

turns out the rear torque arm mounting nuts wer rattled off one was gone one was half a turn from gone neone getting a umi torque arm BUY THEIR HARDWARE PACKAGE lol n lots of good loctite...