- Navigation
Results 11 to 20 of 42
-
10-31-2013, 10:10 PM #11LTX Master
- Status
- Offline
- Join Date
- Nov 2008
- Name
- Enrique
- Vehicle
- 93 Z28
- Location
- Houston/Clear Lake
- Posts
- 615
-
10-31-2013, 10:30 PM #12LTX Master
- Status
- Offline
- Join Date
- Nov 2008
- Name
- Enrique
- Vehicle
- 93 Z28
- Location
- Houston/Clear Lake
- Posts
- 615
would these work? http://www.andysautosport.com/chevro...unts/prothane/
93 Z28, 383, PI 3200, Strange 12 bolt, 3.73, Strange coilovers, suspension, and going 24X... for three years or so.
-
10-31-2013, 10:49 PM #13Lurker
- Status
- Offline
- Join Date
- Dec 2012
- Name
- Tommy N.
- Vehicle
- Silver 1996 Camaro Z28, Green 1996 Camaro Z28
- Location
- El Paso, TX
- Posts
- 946
96 Camaro Z28 Silver Mostly Stock, Full Exhaust
96 Camaro Z28 Green Big Cam, Quick Performance 9 Inch Rear End, Full Exhuast
-
10-31-2013, 11:19 PM #14LTX Master
- Status
- Offline
- Join Date
- Nov 2008
- Name
- Enrique
- Vehicle
- 93 Z28
- Location
- Houston/Clear Lake
- Posts
- 615
-
10-31-2013, 11:34 PM #15Lurker
- Status
- Offline
- Join Date
- Dec 2012
- Name
- Tommy N.
- Vehicle
- Silver 1996 Camaro Z28, Green 1996 Camaro Z28
- Location
- El Paso, TX
- Posts
- 946
-
11-01-2013, 12:41 AM #16Xtreme Member
- Status
- Offline
- Join Date
- Apr 2012
- Name
- Cameron
- Vehicle
- 1994 Formula
- Location
- Dover, De
- Posts
- 2,076
I have the same Prothane mount but I would check with one of our sponsors to see if they can get you a great deal from a trusted seller.
Last edited by Sahara54; 11-01-2013 at 12:45 AM.
2012 Sierra - 5.3, Summit "Stage 1" Truck Cam
1994 Jimmy - LS? LT? 4wd? AWD? Time? Money?
1994 Formula - 5.3, Terminator X, Billet VS7875, "Best Cam", T56, QP 9"
Formula Build Thread
-
The Following User Says Thank You to Sahara54 For This Post:
-
11-01-2013, 01:16 PM #17LTX Master
- Status
- Offline
- Join Date
- Nov 2008
- Name
- Enrique
- Vehicle
- 93 Z28
- Location
- Houston/Clear Lake
- Posts
- 615
So I went to buy this one at Autozone. Is this the correct one? This will not help my problem though. It will only make it worse by raising the trans more. 20131101_113940.jpg
93 Z28, 383, PI 3200, Strange 12 bolt, 3.73, Strange coilovers, suspension, and going 24X... for three years or so.
-
11-01-2013, 02:23 PM #18Lurker
- Status
- Offline
- Join Date
- Dec 2012
- Name
- Tommy N.
- Vehicle
- Silver 1996 Camaro Z28, Green 1996 Camaro Z28
- Location
- El Paso, TX
- Posts
- 946
@383z
Silver 96 Z28 SideSwype-DD
Green 96 Z28 NightMare-Drag car96 Camaro Z28 Silver Mostly Stock, Full Exhaust
96 Camaro Z28 Green Big Cam, Quick Performance 9 Inch Rear End, Full Exhuast
-
11-01-2013, 03:21 PM #19LTX Master
- Status
- Offline
- Join Date
- Nov 2008
- Name
- Enrique
- Vehicle
- 93 Z28
- Location
- Houston/Clear Lake
- Posts
- 615
93 Z28, 383, PI 3200, Strange 12 bolt, 3.73, Strange coilovers, suspension, and going 24X... for three years or so.
-
11-01-2013, 11:32 PM #20Xtreme Member
- Status
- Offline
- Join Date
- Nov 2012
- Name
- Shaun
- Vehicle
- 1994 Formula
- Location
- Phillipsburg NJ
- Posts
- 7,249
Supporting MemberUMI safety loop touches drive shaft??
considering the suspension and motor you have in that car youre probably gonna rip that duracrap rubber mount quick. mine lasted a week, with bolt ons, on stock suspension, stock wavyplate torque arm....
energy 3.1142 is the correct 4l60e mount. it has a different offset than the standard onefitsall poly mount that they had out for years. i have had both on my car, this one doesnt really add vibration, and i have yet to break it. the interlock also has a little more meat to it.
@383zLast edited by SSlowBoat; 11-02-2013 at 12:33 AM.
2021 Charger Scat 392
1994 Firebird Formula 381 stroker - Carrying the torch! - 9.90 @ 134.3mph on a 200 shot
The wrench/driver for LTConvert's 94 Z28- Ellwein 383/LE Trickflows/ D1SC / CPT Ultra Pro Race 4L60E
10.78 @ 125mph. Shooting for 9.99 for Frank Cahall!
-
The Following User Says Thank You to SSlowBoat For This Post:
Bookmarks