- Navigation
Results 1 to 3 of 3
-
03-20-2020, 09:11 AM #1VIP Member
- Status
- Offline
- Join Date
- Dec 2011
- Name
- Mark
- Vehicle
- 1993 Camaro Z28, 2005 Chevy Silverado 3500 Crew cab dually, 2005 GMC Yukon Denali
- Location
- Altoona, PA
- Posts
- 809
Ram Clutches Push Style conversion kit
Has anyone tried one of these yet? Converts from a pull style clutch to a push style with a hydraulic bearing. This popped up as an advertisement on my FB page. Went to their website to check it out. 3 different versions available depending on clutch disc.
https://ramclutches.com/lt1-camaro-converison-systems
Sent from my iPhone using TapatalkLast edited by 1QUICKZ28; 03-20-2020 at 06:54 PM.
Stock bottom end, Impala head gaskets, Stock heads w/stage 2 port polish Comp beehive springs, Crane 1.6 RR's, Thunder Racing cam, Cloyes Billet True Roller TC, Long tubes, custom true dual 3" w/X-pipe, Ported intake with 58mm TB, 36lb injectors, PCMforless chip, Tick Performance stage 3 M6, Strange S60 4:10's True Trac 35 spline axles, MSD complete Ignition system, Summit electric water pump and a ton of other upgrades.
-
03-20-2020, 09:47 AM #2Xtreme Member
- Status
- Offline
- Join Date
- Nov 2012
- Name
- Shaun
- Vehicle
- 1994 Formula
- Location
- Phillipsburg NJ
- Posts
- 7,249
Supporting MemberThere was other conversions out there, but its about time. converts it to ls style, which is a little more reliable than the pull style. I think @blackbirdws6 runs a much more expensive ls hydro conversion.
2021 Charger Scat 392
1994 Firebird Formula 381 stroker - Carrying the torch! - 9.90 @ 134.3mph on a 200 shot
The wrench/driver for LTConvert's 94 Z28- Ellwein 383/LE Trickflows/ D1SC / CPT Ultra Pro Race 4L60E
10.78 @ 125mph. Shooting for 9.99 for Frank Cahall!
-
03-20-2020, 06:55 PM #3VIP Member
- Status
- Offline
- Join Date
- Dec 2011
- Name
- Mark
- Vehicle
- 1993 Camaro Z28, 2005 Chevy Silverado 3500 Crew cab dually, 2005 GMC Yukon Denali
- Location
- Altoona, PA
- Posts
- 809
Stock bottom end, Impala head gaskets, Stock heads w/stage 2 port polish Comp beehive springs, Crane 1.6 RR's, Thunder Racing cam, Cloyes Billet True Roller TC, Long tubes, custom true dual 3" w/X-pipe, Ported intake with 58mm TB, 36lb injectors, PCMforless chip, Tick Performance stage 3 M6, Strange S60 4:10's True Trac 35 spline axles, MSD complete Ignition system, Summit electric water pump and a ton of other upgrades.
-
The Following User Says Thank You to 1QUICKZ28 For This Post:
Bookmarks