Project; "BEATERBIRD"

[zooguy]

Well got the throttle cable adapter on fuel system finished and radiator in and burped.

I decided to go with black steel braided fuel line to the carburetor just to make it a little more discreet. my throttle cable bracket has roughly an inch and a half of adjustability as well as the adaptor where I had to cut off the little hammer on the end of the stock cable. So I have roughly two and a quarter inches of adjustability which is pretty nice I guess

Sent from my SM-N910T using Tapatalk

[zooguy]

Today I also ran it for a little while for the first heat cycle on the header wraps.


Sent from my SM-N910T using Tapatalk

[popo8]

Did I see a milk jug for the overflow?

Im not only an LTXtech member... Im also the Owner.

[zooguy]

I was actually just burping the system that had fresh water in it. I'm going to hide a small tank in front of the passenger tire in the fender

Sent from my SM-N910T using Tapatalk

[popo8]

I was actually just burping the system that had fresh water in it. I'm going to hide a small tank in front of the passenger tire in the fender

Sent from my SM-N910T using Tapatalk

Ok... i was gonna tell u, that would be 2 ghetto. But that makes sense.

Im not only an LTXtech member... Im also the Owner.

[Slow 30th]

But I have seen worse things rigged up


Sent from my iPhone using Tapatalk

[zooguy]

Switches mounted ... now to label and wire them

Sent from my SM-N910T using Tapatalk

[zooguy]

Wired up the starter and ignition https://cloud.tapatalk.com/s/5996209f...814_173158.mp4

Sent from my SM-N910T using Tapatalk

[zooguy]

Well did a little rerouting of the coolant crossover for the back of the heads .... put it in the fender.

This engine bay is turning out very clean.

Need to paint my coolant overflow black still.

Sent from my SM-N910T using Tapatalk

[zooguy]

@Tubby Z28
See the wire loom around the hose as it goes through the hole?

Sent from my SM-N910T using Tapatalk