- Navigation
Results 11 to 18 of 18
Thread: Ballistic17's 95 Formula
-
06-16-2020, 11:07 AM #11Xtreme Member
- Status
- Offline
- Join Date
- Nov 2012
- Name
- Shaun
- Vehicle
- 1994 Formula
- Location
- Phillipsburg NJ
- Posts
- 7,249
Supporting Member2021 Charger Scat 392
1994 Firebird Formula 381 stroker - Carrying the torch! - 9.90 @ 134.3mph on a 200 shot
The wrench/driver for LTConvert's 94 Z28- Ellwein 383/LE Trickflows/ D1SC / CPT Ultra Pro Race 4L60E
10.78 @ 125mph. Shooting for 9.99 for Frank Cahall!
-
06-24-2020, 07:28 AM #12
SS, couldn't you just do the pin out on a regular 0411 pcm out of an Express or the like? In the event it bricks.
Rob.
1996 Z-28 LT1 3.90s, longtubes, cai, ory exhaust dumped at axle, Solomon tuned, rebuilt trans, IG:JUNK_LT1
-
06-25-2020, 08:56 AM #13Xtreme Member
- Status
- Offline
- Join Date
- Nov 2012
- Name
- Shaun
- Vehicle
- 1994 Formula
- Location
- Phillipsburg NJ
- Posts
- 7,249
Supporting Member2021 Charger Scat 392
1994 Firebird Formula 381 stroker - Carrying the torch! - 9.90 @ 134.3mph on a 200 shot
The wrench/driver for LTConvert's 94 Z28- Ellwein 383/LE Trickflows/ D1SC / CPT Ultra Pro Race 4L60E
10.78 @ 125mph. Shooting for 9.99 for Frank Cahall!
-
06-28-2020, 04:18 PM #14
You COULD, in theory, just repin to a full 24x setup and run the OEM 0411 PCM. (Assuming you had the torquehead sensors setup and that PCM bricked)
But you better be good at reading/understanding schematics.
Or, be super cool and just swap to a holleyCorrelation does not imply causation.
Una salus victis nullam sperare salutem
-
The Following User Says Thank You to shownomercy For This Post:
-
06-28-2020, 04:19 PM #15Xtreme Member
- Status
- Offline
- Join Date
- Nov 2012
- Name
- Shaun
- Vehicle
- 1994 Formula
- Location
- Phillipsburg NJ
- Posts
- 7,249
Supporting Member2021 Charger Scat 392
1994 Firebird Formula 381 stroker - Carrying the torch! - 9.90 @ 134.3mph on a 200 shot
The wrench/driver for LTConvert's 94 Z28- Ellwein 383/LE Trickflows/ D1SC / CPT Ultra Pro Race 4L60E
10.78 @ 125mph. Shooting for 9.99 for Frank Cahall!
-
06-29-2020, 06:14 PM #16LTX Member
- Status
- Offline
- Join Date
- May 2020
- Name
- Lee Briggs
- Vehicle
- 1995 Firebird Formula
- Location
- Crookston Mn
- Posts
- 12
-
06-30-2020, 07:05 AM #17
Once you have the 24x sensors on the motor, you can run any aftermarket Holley setup basically. Cheapest is the terminator X system right now.
Downside is you lose the factory dash if you do not add some custom wiring.Correlation does not imply causation.
Una salus victis nullam sperare salutem
-
07-10-2020, 10:34 PM #18LTX Member
- Status
- Offline
- Join Date
- May 2020
- Name
- Lee Briggs
- Vehicle
- 1995 Firebird Formula
- Location
- Crookston Mn
- Posts
- 12
Updated the dim stock headlights to some led's today.
Bookmarks