- Navigation
Results 1 to 3 of 3
-
07-30-2019, 07:56 PM #1LTX Regular
- Status
- Offline
- Join Date
- Jan 2009
- Vehicle
- 1997 Camaro SS, 1996 Camaro Z28
- Location
- Rochester, NY
- Posts
- 227
Rossler 4L80E transmission w/Pro Yank converter and supporting parts
Rossler 4L80E transmission removed from a 4th generation F-body. Essentially, I am offering this as a near-complete conversion for LT1/LS1 F-bodies; however, aside from the crossmember it can obviously be used in numerous applications. The transmission has very little use (less than 400 miles) and only a few passes at the track. Excellent condition with no issues. I have all paperwork from Rossler and will be included with the sale. Rated for 900-1000hp.
Specs (from paperwork):
- Rossler 4L80E transmission ($3277 new)
- Aluminum H/G drum ($645 option)
- Reprogram valve body ross/lock
- Modify pump TCC apply system, increase load capacity on converter clutch apply
- Overhaul complete transmission, set to HD specs
- Add extra clutch capacity to direct clutch drum
- Install special ex.wide bushing/pump stator
- Install HD (no walk bushing) rear case
- Install rear case retainer and bearing kit, prevents rear case thrust washer failure
- HD kevlar rear band
- 34 element sprag kit, 2nd gear
- Allison filter conversion kit
- HD intermediate band
- 2 shift solenoids
- New PSI force motor
- Turbine in, turbine out switches
- New internal wiring harness
Additional items:
- Pro Yank 3400 converter ($1050 new)
- Speartech 4L80E add on harness ($200 new)
- BMR 4L80E transmission conversion crossmember (part number TCC008) ($180 new)
- B&M Transmission super cooler, part number 72064 ($80 new)
- B&M drain plug ($8)
- Autometer trans temp gauge ($65 new)
Over $4850 for this set up new. Asking $2900 for everything
Located in Rochester, NYLast edited by JasonShort; 08-14-2019 at 08:55 PM.
-
08-14-2019, 08:56 PM #2LTX Regular
- Status
- Offline
- Join Date
- Jan 2009
- Vehicle
- 1997 Camaro SS, 1996 Camaro Z28
- Location
- Rochester, NY
- Posts
- 227
I will also throw in a nearly new Denny's Nitrous Ready 3" steel driveshaft that was used with this setup. The drive shaft was $600 new.
-
08-29-2019, 07:04 PM #3LTX Regular
- Status
- Offline
- Join Date
- Jan 2009
- Vehicle
- 1997 Camaro SS, 1996 Camaro Z28
- Location
- Rochester, NY
- Posts
- 227
Sold, thanks
Bookmarks