- Navigation
Results 1 to 3 of 3
Thread: Vette wheels
-
05-01-2018, 05:26 PM #1LTX Master
- Status
- Offline
- Join Date
- Jun 2013
- Name
- Beaver
- Vehicle
- 1994 camaro Z28
- Location
- KENTUCKY
- Posts
- 600
Vette wheels
Would the 2011 later wheels fit the 96 z28. There 18x10 front 19x10 rear. Well the work
Sent from my SM-G930R6 using TapatalkBEAVER
94 Z28,4A,LLOYD SG CAM,1.6RR,SHIFT KIT,2,800 STALL,HEADERS,HEADS PORTED & POLISHED,ALL INTERNAL ENGINE PARTS LUNATI !!!
-
05-01-2018, 08:17 PM #2LTx Guru
- Status
- Offline
- Join Date
- Apr 2013
- Name
- Fred
- Vehicle
- 1994 Formula - SOLD
- Location
- Central NJ
- Posts
- 2,279
They are a 5 x 120.65mm (4-3/4”) bolt circle, so that's the same.
Charts show the 19” x 10” for the base car as 79mm offset; 19” X 10” for the ZR1, ULZ Carbon Edition, and Z07 as 40mm offset. Which ones are you asking about?
No 18” X 10” shown. There was an 18” X 9.5” 40mm offset used on the 2011 Grand Sport and Z06.
40mm offset pushes the wheel toward the outside edge of the fender. 79mm offset pushes the wheel deeper in the wheel well, and may require spacers. If you can pin it down to the specific wheel, exact width and offset, I can tell you if it will work.
Here's the best source of info:
http://image.mamotorworksmedia.com/p...ence_Guide.pdfSOLD - GONE TO A (VERY) GOOD HOME ! - 94 Formula A3+1: 381ci forged stroker - Callies Stealth, Oliver 5.85 billet rods, BME nitrous pistons / CNC LT4 heads / CC solid roller / TH400+GearVendors OD / 4.11 Strange 12-bolt / 300-shot N2O / Spohn Suspension / roll bar / MoTeC M48 Pro engine management system /a few other odds 'n ends.
-
05-02-2018, 01:52 PM #3LTX Master
- Status
- Offline
- Join Date
- Jun 2013
- Name
- Beaver
- Vehicle
- 1994 camaro Z28
- Location
- KENTUCKY
- Posts
- 600
I'm not sure but they was on an older z28,a 69
Sent from my SM-G930R6 using TapatalkBEAVER
94 Z28,4A,LLOYD SG CAM,1.6RR,SHIFT KIT,2,800 STALL,HEADERS,HEADS PORTED & POLISHED,ALL INTERNAL ENGINE PARTS LUNATI !!!
Bookmarks