- Navigation
Results 11 to 13 of 13
Thread: Turbo headers
-
01-16-2018, 07:20 AM #11
Yes some will fit.
There have been two uses of em on this site, and neither was in a 4th gen fbod. That is your risk. Most if not all SBC headers will not clear the fender towers (or whatever their called)
Its cheaper, IMO, to buy fbod specific mids/shorties, and weld up a reverse crossover.
Don't forget everything that will need to be moved to fit a turbo, and all the supporting crap a turbo requires. It ain't cheap.
Fast, reliable, cheap. Pick two. Personally I went cheap and fast.Correlation does not imply causation.
Una salus victis nullam sperare salutem
-
The Following User Says Thank You to shownomercy For This Post:
-
03-03-2018, 01:44 PM #12
I just finished with my build...l I bought a new BW s480... I belive I paid around $900... found a set of used BBK shorties and then fabricated my own hot and cold side.... I bet I have less than $2K invested for everything, minus the boost controller.... if you like to fabricate and have the skills it can be fun and save some coin.
96 Vert 383 forged AFR 210 LT4 Intake CP Pistons T400 Moser 9" Borg Warner S480
-
03-03-2018, 02:15 PM #13
Bookmarks