- Navigation
Results 1 to 10 of 10
Thread: LS1 SS spoiler wiring
-
02-22-2014, 03:10 PM #1
LS1 SS spoiler wiring
Does anyone know how to wire the brake light for an Ls1 SS spoiler on my LT1? I know I can use a relay, came across a diagram but I'm not sure what color wire goes where? Any help would be appreciate it! Thanks
-
02-22-2014, 04:07 PM #2
Your old spoiler should have a brake light when you take it off just connect your new spoiler light to that if you need to cut the end of the old spoiler light and connected it to the new light I believe there's only two wires 1 power 1 ground
Last edited by tleed; 02-22-2014 at 04:12 PM.
forged 383,9.6:1,280xfi, trickflow heads,edlebrock lt4 intake,moser 12 bolt w/373
-
02-22-2014, 04:19 PM #3
-
02-22-2014, 04:22 PM #4
LED's work with less voltage it should be fine I put an aftermarket SS spoiler on 1 of my other cars and that's all i had to do and it worked great
forged 383,9.6:1,280xfi, trickflow heads,edlebrock lt4 intake,moser 12 bolt w/373
-
02-22-2014, 04:32 PM #5
-
02-22-2014, 04:38 PM #6
If you switch the whole tail light harness for the rear lights then you have to repen in the connector if you're just swapping spoilers then its fine
forged 383,9.6:1,280xfi, trickflow heads,edlebrock lt4 intake,moser 12 bolt w/373
-
02-22-2014, 04:51 PM #7
Alright that would be great! Thank you
-
02-23-2014, 10:05 AM #8LTx Guru
- Status
- Offline
- Join Date
- Apr 2013
- Name
- Fred
- Vehicle
- 1994 Formula - SOLD
- Location
- Central NJ
- Posts
- 2,283
Shoebox to the rescue.....
http://shbox.com/1/relay_for_ss_spoiler.jpgSOLD - GONE TO A (VERY) GOOD HOME ! - 94 Formula A3+1: 381ci forged stroker - Callies Stealth, Oliver 5.85 billet rods, BME nitrous pistons / CNC LT4 heads / CC solid roller / TH400+GearVendors OD / 4.11 Strange 12-bolt / 300-shot N2O / Spohn Suspension / roll bar / MoTeC M48 Pro engine management system /a few other odds 'n ends.
-
02-23-2014, 08:06 PM #9
http://ltxtech.com/forums/showthread...spoiler+wiring
Here you go. This thread should be what you're after.. my write-up is on post #12Josh 1994 Z28
M6 Converted - Intake - Exhaust
-
02-24-2014, 06:27 AM #10
Bookmarks