Modded- Dyno numbers!

[HoLLo]

To the OP: Looks good, mine should be in that range. I am similar in mods. Just a LITTLE more for 300+ .

[VendettaV8]

what are the mods in yur sig, i cant see your sig?

[Colossus]

I just did 283 rwhp and 323 rwtq yesterday. PS LT's and ORY with a 4 inch mufflex and K&N CAI, underdriven crank pulley, ported mass air, and an air foil. My A/F started just below 11:1 and at just about 4500 rpms fell off the chart. They said I left up to 20-25 hp on the table. Numbers seem pretty comparable to mine.

[96lt1m6]

I just did 283 rwhp and 323 rwtq yesterday. PS LT's and ORY with a 4 inch mufflex and K&N CAI, underdriven crank pulley, ported mass air, and an air foil. My A/F started just below 11:1 and at just about 4500 rpms fell off the chart. They said I left up to 20-25 hp on the table. Numbers seem pretty comparable to mine.

i bet you would gain most of the power by removing that "ported maf" and installing an unported unit.

[Camaro_94]

Nice!!

- Mike

[Colossus]

Think it really hurt me? By how much? I was just borrowing a friends. I can put my descreened one back in.

[1hottcamaro]

mine was really close to your numbers 292/321.
I have Long tubes, ORY, EWP, CAI.

[96lt1m6]

Think it really hurt me? By how much? I was just borrowing a friends. I can put my descreened one back in.

really hard to tell how much power is left on the table. lt1s have a real problem with "ported" maf sensors,it also seems as though you just placed it on your car without having it tuned by what i read! i would put your stock maf back on....is your pcm tuned?

[Colossus]

Nope. Its going to be tuned in the near future. They told me I left about 20 hp on the table. AF was pig ritch.