Currently street tuning I have seen 14-15 psi. Up to 18° and seems good
I changed to a larger filter and ks7 knock sensor. Getting some gains on timing and afr changes.

Catmaigne

Whatever the filter is that comes with the kit.

SSlowBoat

I took a quick measurement. When I can get under the car again I'm sure I could adjust the plastic section and move the whole filter down to get somthing longer on there.

shownomercy

Looks like I could try the 6 x 9 with the 3.5 flange with the room I have.
The 7 inch already very close to intercooler but I could angle a slightly larger one. If worse comes to...

Lol in failing at tagging here 😂😂

z28pr0jeck

I honestly dont know the answer to that.

I am pretty much at sea level

@shownonercy

What do you recommend?
The filter I have now is 4.6 at the base and 7 inches long and I would guess about 3.5 at the cones tip

Brute speed shows another 3.5 inch filter that...

Z28pr0jekt
I bough the system 2 years ago but the guy I got it from had it for a few years but never actually ran it. So the filter is old but was never used.

@JOATMAN
Yep 500rwhp on 93 was my...

SSlowBoat
MoeHorsePower
Z28pr0jekt

Took a look and seems like my air filter is collapsing in on itself. That would be quite a restriction right? As the words my tuner used were "somethings...

SSlowBoat thank you very much.

I guess I have a lot to think about. I'd like to do a front mount but I'm not all about cutting the bumper.

What would you say would be the max amount of psi ...

1 3/4 for like 2 inches to 1 7/8 into a 3 inch collector. The exhaust is 3 inch all the way back to the muffler. The muffler exits come out on one side both being what I believe is 2.5. The muffler...

Cam is 223/235 114lsa

TFS 21° 180 heads ported by lloyd elliot.
He said 215cc at 295/230 flow.

MoeHorsePower

I don't have the dyno graph unfortunately but from some logs I have on hptuners it typically enters boost around 2800-3000rpm. Up around 5800 I'm at 10.6 psi so around 6500 is where...

JOATMON I copy pasted my original post from another post I made and yes I forgot that information there as well lol

Car made 400rwhp. I was expecting at the least 500rwhp on 93 even with the 3"...

Z28 I understand thank you. My buddy said evey 1 compression difference is like 1 psi of boost.

From research I believe the car can take 17-19° over 14°.

3-5° would yield the results I was...

Currently running a Dual intercooler D1SC. I've hit 13psi on the dyno with mild tuning.
The bottom end is forged but not specific to boost.
I'm pretty sure the tuner was being very conservative and...

234/244 .598/.614 110lsa

Cam has about 200 miles on it.

​​​​​​​$300 obo, plus shipping.

I'm looking to purchase the slp 2OTL or Dual Dual system

Accel 36lb injectors. Less than 1k miles $200
TFS 7.150 pushrods couple hundred miles $80

As title says. With or without bolts doesnt matter.
​​​​​​​

Still have throttle body?

Still have the throttle body?
Its been a year, how low will u go?
Dont want to make an offer that will offend you haha.

Ok so here's a small update. Learned my tps voltsge was a little high. It was at .67 like a stock lt1.
But I guess the ls1 pcm likes .55 ish
I adjusted it and for the few minutes I had to let the...

What would cause STFT on bank one to be much higher (positive 20 to 30%) than on bank two?
Bank two will be negatives about 10% but go away under throttle.
Bank one will continuously show positive...