- Navigation
Search:
Type: Posts; User: GVMV
Search: Search took 1.04 seconds.
-
12-19-2010, 06:26 PM
Thread: Bearing Diagnoses
by GVMV- Replies
- 2
- Views
- 525
Bearing Diagnoses
I purchased a block off craigslist (even hauled it around in my camaro for a few weeks till could get home and drop it off :P ) Person that had it didn't know the story on it, had been given to him...
-
06-10-2010, 10:29 PM
Thread: summit opti
by GVMV- Replies
- 9
- Views
- 931
I have put almost 1200 miles on my Summit Opti...
I have put almost 1200 miles on my Summit Opti since I got it few weeks ago. It is working perfectly at this time. I haven't been easy on it, last weekend took a 500 mile round trip around back...
-
05-30-2010, 10:27 PM
Thread: My adventure at replacing Optispark.
by GVMV- Replies
- 17
- Views
- 9,571
Ya I didn't take the hub off, just the harmonic...
Ya I didn't take the hub off, just the harmonic balancer . I did have some issues figure out how to get it off, should of looked at the books first. I rented a harmonic balancer puller to find out it...
-
05-29-2010, 05:48 PM
Thread: My adventure at replacing Optispark.
by GVMV- Replies
- 17
- Views
- 9,571
139.99 @ Summit, which was $10 cheaper than a...
139.99 @ Summit, which was $10 cheaper than a Reman at the local parts house. I always like New for cheaper :)
Quality looks good and couldn't find any differences between it and the original.
... -
05-27-2010, 09:17 PM
Thread: My adventure at replacing Optispark.
by GVMV- Replies
- 17
- Views
- 9,571
Ya looks like timing chain cover gets to wait. I...
Ya looks like timing chain cover gets to wait. I did get it on day before yesterday, I started it and it started to rain. I got it buttoned up yesterday and have now put 50 miles on it :P
Here are... -
05-24-2010, 10:31 PM
Thread: My adventure at replacing Optispark.
by GVMV- Replies
- 17
- Views
- 9,571
Ya if I wasn't doing it in a motel parking lot, I...
Ya if I wasn't doing it in a motel parking lot, I would be pulling timing chain cover off and replacing the seals, I have a oil leak from from front main seal it looks like, but it's going to have to...
-
05-24-2010, 09:15 PM
Thread: My adventure at replacing Optispark.
by GVMV- Replies
- 17
- Views
- 9,571
My adventure at replacing Optispark.
So replacing optispark, for those who haven't seen my other thread, died , won't run. Replaced ICM and Coil. Have Fuel pressure. Have spark and Injector Pulses. No SES codes or light.
My... -
05-18-2010, 10:49 PM
Thread: Troubleshooting non running LT1
by GVMV- Replies
- 7
- Views
- 2,725
Interesting, I wouldn't think if the ECM doesn't...
Interesting, I wouldn't think if the ECM doesn't know your are trying to start the car would enrich to start it, I am getting a enrichment injector pulse on trying to start and then a normal injector...
-
05-17-2010, 08:34 PM
Thread: Troubleshooting non running LT1
by GVMV- Replies
- 7
- Views
- 2,725
I can smell fuel out the exhaust after I try...
I can smell fuel out the exhaust after I try starting it, and plug had fuel on it when I pulled it to check it and make sure wasn't a plug issue. I don't really want to throw parts at it either but...
-
05-16-2010, 11:30 PM
Thread: Optispark brands, whos is better?
by GVMV- Replies
- 69
- Views
- 11,010
Did you find a dynaspark? Website is here...
Did you find a dynaspark?
Website is here http://www.dynaspark.net/
But can't order online says to e-mail them. sales@dynaspark.net
Since in the market for a new optispark this thread was... -
05-16-2010, 01:07 PM
Thread: Troubleshooting non running LT1
by GVMV- Replies
- 7
- Views
- 2,725
Troubleshooting non running LT1
I had another post but it's pretty long and now going to condense into one post.
I was driving down the freeway and car sputtered and just died.
No engine codes now or check engine light... -
05-10-2010, 02:49 PM
Thread: Need Opinions.
by GVMV- Replies
- 16
- Views
- 1,845
So I guess I should replace opti next?
So I guess I should replace opti next?
-
05-07-2010, 08:52 PM
Thread: Need Opinions.
by GVMV- Replies
- 16
- Views
- 1,845
I have spark at the #1 plug so assume spark at...
I have spark at the #1 plug so assume spark at the others and must have spark at coil since have spark at plug. Coil was replaced with ICM. I have Fuel pressure at rail, spark at plug but won't run,...
-
05-06-2010, 11:36 PM
Thread: Need Opinions.
by GVMV- Replies
- 16
- Views
- 1,845
Fuel pressure is good 40 psi on key on, and 40-45...
Fuel pressure is good 40 psi on key on, and 40-45 cranking.
-
05-06-2010, 09:39 PM
Thread: Need Opinions.
by GVMV- Replies
- 16
- Views
- 1,845
Replaced ICM and Coil Still no go. Vince
Replaced ICM and Coil
Still no go.
Vince -
04-18-2010, 01:21 PM
Thread: Need Opinions.
by GVMV- Replies
- 16
- Views
- 1,845
So back at car, will go into diagnostic mode, no...
So back at car, will go into diagnostic mode, no trouble codes.
Try to start just spits and sputters barely turning over, doesn't really catch and run.
So should try ICM? -
04-17-2010, 11:02 PM
Thread: Need Opinions.
by GVMV- Replies
- 16
- Views
- 1,845
Sputtered twice and died. Does nothing but...
Sputtered twice and died. Does nothing but sputter a little bit but doesn't take when hold pedal to floor and try to start.
On fuel pump have pressure at rail, can here fuel pump come on and stop... -
04-17-2010, 08:11 PM
Thread: Need Opinions.
by GVMV- Replies
- 16
- Views
- 1,845
Need Opinions.
So was driving home from work, down the freeway at 65. Car stuttered twice, then died. Now doesn't run, just spits and sputters just a little bit. Not even enough to get started. No Check Engine...
-
04-29-2009, 06:50 PM
Thread: Complete LT1 Intake
by GVMV- Replies
- 5
- Views
- 1,571
Still available, not sure how someone would think...
Still available, not sure how someone would think a intake is cheap to ship to Florida. OH well so have shipping quote to Florida of $60. I am willing to do $130 shipped since was willing to sell it...
-
04-24-2009, 01:36 AM
Thread: Complete LT1 Intake
by GVMV- Replies
- 5
- Views
- 1,571
Complete LT1 Intake
Complete LT1 Intake $130 shipped
Was stockpiling parts but want to get my 77 going and so close :P... -
11-02-2008, 05:54 PM
- Replies
- 3
- Views
- 436
Rings should smoke all the time, if you let off...
Rings should smoke all the time, if you let off the gas then get on it and you get a puff of smoke that is valve seals. I would try replacing valve seals first. You can do it on the vehicle but I am...
-
10-12-2008, 05:38 PM
Thread: what years of vette rims fit my 95?
by GVMV- Replies
- 11
- Views
- 2,166
So 93-96 Have 55mm backspacing so will 56 mm...
So 93-96 Have 55mm backspacing so will 56 mm backspacing rims work?
I found this link talking about spacers for 3rd Gen's but has listing of backspacing and years.... -
10-12-2008, 01:08 PM
Thread: Camaro guys, come on in.
by GVMV- Replies
- 46
- Views
- 3,402
http://the-michels.com/albums/93Z28/93z28rear.size...
http://the-michels.com/albums/93Z28/93z28rear.sized.jpg
Magnaflow tips -
10-04-2008, 01:35 PM
Thread: New member
by GVMV- Replies
- 7
- Views
- 829
Welcome to the site. Pictures?
Welcome to the site. Pictures?
-
09-29-2008, 07:14 PM
Thread: AWESOME! Hellooo LTx Tech. Wuz up?
by GVMV- Replies
- 16
- Views
- 1,083
Nice car.
Nice car.
Results 1 to 25 of 48