Found that the MAP sensor seal was torn up, got a better one on it and it reads almost 10 kpa higher than before (around 54-55 kpa at idle). Also replaced a burnt spark plug wire. Car is running a...

The wideband is just after the Y pipe comes together. The plugs show that its rich but the ones I pulled didn't look too bad. I don't have BLM's from when it was at 12.3:1. I have some from when I...

I got a few traces with Scan9495 today. Wasn't able to see anything different. Going to put the old O2s back in since they ran at about 11:1, and since I put in the new ones it has been running at...

Ok, I see now looking at the data in a .csv that the BLM cells are correct. I believe the fans do kick on, although I notice when I stop in traffic that it will climb up on the gauge from 180 to...

Yeah PM me youre email and I can send you a log. Don't think I can attach it on here.

Yeah I replaced the narrowband O2s. The wideband is an AEM and the wideband O2 doesn't require calibration. I'm not really sure if there is a way to be sure that it is reading correctly besides...

Didn't have access to the car for a couple weeks while moving, so I'm back to troubleshooting again.

What would you take it to mean if the WOT pulls are reading BLM cell 17? The TPS output is at...

Yeah thats true. I'll try to get it without the connector. The harness pins looked fine. Based on shbox I believe that I'd be seeing too low of a resistance instead of too high. Although if in...

I'll have the other sensor this weekend to try that out. Tapped the connector to get resistance of the sensor since I couldn't get leads directly onto the sensor and got 1550 ohms which puts the...

Checked the wiring and got 5V. Couldn't get the leads to read on the sensor before dark. The computer read around 125 deg after sitting for a full day with both the old and new sensor. Going to...

I recently noticed at WOT my AFR is reading around 11:1. I haven't changed the tune in 2 years, and it was running around 12.5:1 at WOT up until I noticed this. Took a log and found that the...

Turns out ABS was working fine. I just couldn't feel it in the same way I did my other car, so I got thrown off.

Alright thanks for clarifying that. I'm going to do a fluid flush since its pretty old and see if that has any effect on it.

Yep. From 45 MPH I did a test emergency stop. Saw the Low Trac light come on, but didn't feel the ABS doing anything. The pedal stopped dead. It was in the rain and it didn't really feel like it...

Basic booster checks seemed all good.

Not sure what's going on exactly. ABS inop is not on, but it won't engage ABS. The pedal gets hard before it feels like it should. Fluid is good, and the pads shouldn't be too worn. Car does not...

Bump. Still have this stuff trying to clean house.

ttt

ttt lowered some more

Bump lowered prices

Pm'd

ttt

3183431835318363183731838318393184031841

I'm trying to clear out some spare parts that I have laying around from my rebuild.


Used TB (no bottom piece) -$15


Exhaust hanger (http://shbox.com/1/exhaust_system.jpg #29, don't have a...

I recently went to replace the fuel filter (long overdue) and the metal side of it is extremely rusty. I have tried to get it loose, but I'm going to have to cut it out and replace that section of...