Going off of all the positive feedback you guys have given, I went ahead and ordered one. Will post my thoughts after I get everything together.

Any of you guys using the Hooker Aerochamber cat back or know anybody who has? How do you like it? how is the fit and sound? Cant find much in the search. Thanks

Hi, I finally got my project running descent with a base tune using the factory LT1 MAF.

My Set up is as follows:

Pump gas 383 LT1 with forged 4 bolt bottom end, 12.0-1 compression, LE2 ...

Sold! Thanks.

$225 shipped.

38816

38815

I have a Nitrous Outlet Mono Blade Nitrous plate for gen 2 LT1. This plate is used but works great. I have the short Nitrous Outlet hard lines that go from the plate to the solenoids and the bracket...

Sold!

$650 shipped

700 shipped o.b.o.

38107]

I have a new in box Pro-Built Automatics, Pro Street Elite rebuild kit for a 4L60E. This kit is rated at 750+ horsepower. I also have a new Delco reverse input drum included.

This kit is spec'd...

Just wondering if any of you guys run a 250 shot thru a plate, with the stock intake?

I know I am safe with a 200, but would like to try a 250 if possible. I have all the supporting mods, just...

Yes it is. Pm sent

Never received a message. Still for sale

$125 shipped

It was on my 95 t/a, which I believe is obd 1 with an obd 2 plug. So it should work fine

How much for just the rear pads?

I am selling my LT1 scan master. Shows real time info. Monitors knock, IAT's, O2 sensors, shows fault codes, ect. Works great. I have the instruction manual that came with it that has a lot of Good...

Well, I think I am leaning toward the aem 30-0300. It looks pretty nice for the cost and the reviews seem pretty good. And I believe I will be able to data log with it. They run about $165 on Ebay...

Hey guys, I'd like to get set up to start tuning my 95. I would like to pick up a wide band in about a month, so I figured I'd start researching my options right now.

I read through the stickies,...

Sold!

I have a set of Comp 26918 beehive valve springs with Locators, steel retainers and Locks for 11/32 valves stems. These springs are brand new however I did install them on my heads, but I changed my...

Actually I just purchased a set yesterday. I Emailed BTR and they offer their platinum spring kit for the gen 2 Lt1. The only issue is that the valve guides need to be machined down to .500" for the...